Perlesmith TV Wall Mount Unboxing, Install Tutorial, & Review

My leveling bolt is tightened all the way but the tv still goes off level every time I move it in and out of the wall. I can see the tv swiveling at that point where the leveling bolt is. Any ideas for how to fix that?

What’s a 5 30 second drill bit?

what size drill bit and screw is good enough? my screws wont go all the way through the stud in the wall

clear cut instructions. couldn’t have done it without you! thanks man

Can you tell me what knife that is you used to open the package?

Thank you so much!

Just curious to know, what screws am I using to screw the mount to my tv? It fits perfectly without the arms, but the screws don’t fit down. Do I use the spacers? If so do they go on to the screw before I drill them down?

Thank you for the tutorial! It was super helpful. I plan on setting mine up tomorrow with the help of my husband!

Is it possible to have it pushed in at top so it's only 3 inches off wall at both bottom and top?

Love the simple step by step and great honest review. T Y

Thank you I needed this

can you rotate it 90 degrees because i want to use it but i want to be able to have it fully rotated

I can't find it in amazon

My mount isn't tilting for some reason... it will swivel, just no tilting motion

Hey buddy do you know if it comes with screws to attach the mount base to the TV? I do not have mine smh

Well done! Unfortunately the biggest hassle was attaching the wings on the bracket that attached directly to the tv. I have a 55” Samsung which is the largest tv for this mount and I had to use 2 of the thick spacers along with two of the small spacers for each screw but it worked and with my Son’s help we got it up on the wall, thanks again for your video.

Great review and we share the same last name my friend

Very helpful. Most definitely need 2 people.

Could u please tell or show me how close it turns to 90°? I ordered a wall mount a few months ago and mine doesn’t turn enough to reach my bed. So I just bought this in hopes that it will turn enough. Thanks man.

A bit confused for how to know if I am drilling right areas for the mount. So far this has been the best most helpful video but I'm a bit confused on the drilling.

None of these screws that came with my Mount. Fit in the back of tv. The largest long ones do… but too long. The short ones of largest aren’t long enough. And the washers won’t fit if they are the larger screws