The Gas Chainsaw Powered Railroad Impact Wrench

In the past we made the 1st gas gun at 100K subs, and the 2nd at 200k. But when you put a chainsaw impact together and it works, you don't just let it gather dust in the corner until some number is hit. Enjoy!

I bet you could get pretty close results from the original engine with some tuning. the original just sounded like it was never really spinning up to the point where the 2 stroke becomes self supercharging. considering the original was designed to run all day everyday its for sure under tuned. I bet adding a flywheel into the mix would really up the power too letting the 2 stroke run wide open

You found a secondary usage for the chainsaw wtench: glitter factory. It turbed that gearset to powder!

Tayrl mentioned your channel on his latest video so you may notice the number of subscribers will increase ,I'm included!

Where Is The Nitro?

You need to grow another arm

So what youre saying is, that you need to mate an F1 engine to it!

These people are THIRSTY lol look at that most replayed Stihl knows what they are doing lol

Obviously the only logical s tep from here is to hyabusa swap it.

What in the Crystal Methodist is that

This video deserves more views!

He must’ve tightened my oil drain bolt

This is almost as silly as the video of a guy cutting lumber with a 12” miter saw blade on an angle grinder.

LMAO 🤣

The only pic of a stihl 881 you could find…

I know this is late, but could you give me some insight on how you attached the hammer and anvil to the clutch? I’ve been looking for a clutch for a while that could fit into my 1/2 inch hammer and anvil, which is a female end.

nice picture of the ms881. i would have chose that picture too to demonstrate ... um, stuff

Can you do one with a 2L car engine?

Love how everyone I appreciate loves our boy Cleeter as well 🔥🙏👍

You speak like and Australian. Not your accent, some of your vocabulary and humour.

How is the gear shift system back and forth?