Stained Glass Basics (How To Copper Foil A Beginner Panel)

Where did you get the widget used for holding copper foil?
Where did you get vacuum sucker for fumes?
Thanks!

Do you notice a difference in the bead when you hold the iron tip perpindicular rather than horiz?

Great video, thanks! Just wondering if you'd have a link to the file for the tape alignment tool? Would very much like to 3d print one myself

I don’t even know how to make stained glass yet, but I’ve soldered a ton doing plumbing, and I suggest that you use gloves while adding the foil and soldering as so the gloves keep oils from hands messing up the process

Inherited a bunch of glass and some olllld tools. Ive been itching to try it out. This was the most detailed tutorial I've seen. Thank you so much.

I was looking for some mixed technics for change an old cheap piece of furniture. You inspired me and I think I'll give it a try! Ty!🙏

How do you know when you need to reapply flux? Great video! Super succinct and helpful.

Great video; thank you!

Nothing more irritating in a demo video than watching people toss around tools and materials. You’re impressing no one with the carelessness.

When cutting/scoring the glass, I noticed you always pushed the cut never pulled it, did that make any major difference of is that just how you personally do it? Also you mentioned always makeing sure the cutter a well oiled, but didn't say with what in specific oil is recommended to use?

Would your copper foil jig work with most shapes of glass?

Fantastic! Absolutely fantastic. Just learnt a Shiz load😁 Thank you.

I've never known anything about how stained glass is made. This is a thorough and clear introduction. Thanks!