How to Wire a Profibus Cable to a Profibus Connector

This is a tragedy. The author of this film did not notice that we are in the 21st century. He stopped in the mid-20th century. How can you show cable processing with an ordinary knife nowadays? I'd like to see what he did up close. What does the insulation of the wires look like? I know that sometimes he will do better, sometimes worse. I have seen the work of such specialists many times. I know that there are people who learned how to peel cables with such a knife 20 years ago and will continue to do it for the rest of their lives. But it is very harmful because when a young person watches it, he or she learns bad habits. Now there are tools to help you do it professionally.

In the inside of the wire connector, why is there two sets of clear plastic wire inserts?

You teaching best shit. The baddest way to do this.

tqqqqqqq i love you

you didn't say anything about setting the resistance, it looks like your connector is the last one so you need to set the resistance, but overall a very good movie, thank you.

I use a RG58 stripping tool. Very effective and way less expensive than the Siemens ome

😍😍

thank you very much...We hope for more practical videos
😍

great sweater!

En español

Very helpful

Thanks it's hopefully

This is easily the best channel for automation

So are these cables still used? Or has pretty much everything gone to ethernet cables?

Thank you for sharing.🙏

I feel free to say thanks for this video.

Thank you

Set dip switch connect profibus

thank you bro

What about the terminating resistor, is it inbuilt, if yes, where?

Thanks for the video. It was very educative

Perfect job

Excellent explanation as always Real Pars. I have a question. Is it necessary to strip the green and red wires, and leave the conductive material visible? Or are they just connected as they are to the DB9 terminals?

Thanks so much for this valuable video. I have one simple question, why the two cores are inserted in only one path of the two paths connector?

Thank you real pars team for another high level contant video . I really like your channel.. the best one across the net.

Very nice ..sir ..

Very beneficial video..Thanks

Thank you so much!

Why does a two wire cable require a DB9 nine pin connector?

sir can you please guide how to check profibus signal

I find it a lot easier to strip cables in general with just the blade

All of the RP videos are first class - clearly explained and to the point. Cheers!

Very helpful

Please make on device net

tanx for addt'l lesson

Very helpful

Nice work sir

Please explain different components of the panel you are working on.

I want to pursue my career ahead in automation..I have been searching a lot of videos where I can find relevant and useful information from where I can enhance my knowledge.I find myself really lucky to have found this channel which have really helped me in learning as well as understanding in a very easy language..Thank you @Realpars ...it's been the best automation channel to learn from..looking forward to much more videos..keep up the great work❤️🙌

This is the best channel about automation. All videos are helpful, even to know new skills or refresh what been learned. Thanks a lot.

REALPARS as always you are the kings of automation training, Can you make a video about all the components used to establish Profibus network

Thanks

please make a video how to check good or faulty profibus connector ( vipa plug)
Thanks....

Yes easy, thanks realpars

Thx lot.. fantastic video

There is a provision for connecting two profibus cables in a single profibus connector. Why is it so??

Can you make video on olm
Operation installation and troubleshooting.

Dont we need to remove that last layer of insulation as like we normally do for regular electrical wire connections?

Thanks for sharing and teaching us always, i see that there is nothing complicated about making a profibus cable termination to a profibus connector. It's all thanks to the RealPars team.

Very useful instruction. Thanks!