Комментарии:
AFTER SEEING YOUR VID i am more confused as to conecting which wire from the relay did you use i,e, nc or com or no to which side of the led
Ответитьlittle plastic thing ?? do you mean (A JUMPER) bad explanation whole video
ОтветитьDude explain the outputs are you using NO,NC or com
ОтветитьPerfect for Airsoft claymore either deploy or toggle on off for setting claymore with PIR motion detection sensor so off while setting remote control arming of pir sensor otherwise it will deploy on yourself
Ответитьhi is this able to run two fog lights around 20amps
ОтветитьSir my car remote locking receiver is not.getting signals from key fob. How to repair it??
ОтветитьHow do I make the continual beep stop?
ОтветитьThank you very much for the video, I have one question, how can we do the open and close with a clock, 5 PM open 7 PM close.
Ответитьcan i use it for an RC car
Ответитьdoes work any transmitter with any other receiver
Ответитьsend link to buy this transmitter and reciever
ОтветитьI want to make a receiver control any remot
ОтветитьHi, i purchased this unit but can't accomplish to LEARN the remote controls.
Once i had succeeded but don't remember how. Anyway when i turned DC off and then started again - it lost all the memory.
How do i learn the Keys and how to i SAVE them for a future in the memory of the module?
Thanks
easy . use as remote car starter
Ответитьwhat is the range
ОтветитьHow do ya use it to open a garage door? Not sure on the wiring, and unable to find a good diagram
ОтветитьAny receivers that do not require 12 volts? I want to make something portable
ОтветитьThe little plastic thing is called a jumper.
Ответитьis the little plastic thing important as mine never had one when it got delivered maybe thats why mines is not working what can i use in its place
ОтветитьThanks mate, u solve my problem !!! cool
ОтветитьCan you run the receiver on the nine volt battery
ОтветитьWhat are the dimentions on the circuit board inside the remote?
ОтветитьHey what was your website?
Ответитьi cant control it :( i do the same method like u . my led wont light up but the relay works
Ответитьi tried doing that with a 5v dc motor but after i connect the wire the motor starts to spin with out my command, what did i do wrong? :/
Ответить