INSTALLING 15KW SOLAR PV SYSTEM "Start to Finish "

I did not see an RCD anywhere in your installation ? Well laid out installation

The panels themselves should be grounded to Earth ..The SPD is not enough especially in a large setup like this

This is bad because only 1 inverter was enough with those amount of solar arrays the customer trusted you and your calculation otherwise good job.

Excellent job

Nice job

I wss expecting you use ferrules to avoid loose contacts over time

DC 😊Cable connectıon not safe

In the setup was each inverter and battery connected to separate loads in the house
Like each controls his own load ?

What is the size per batteries?

Did you wire the batteries in parallel or series? what are the capabilities per batteries?

Thats what I call the informative video. All my installation doubts are cleared.

NICE🥰🥰

Good job

Do you carry out work in lagos??... and also how much will the 15kwh battery cost now?

Are u guys in Nigeria??

Neatly done job. ❤ how can I contact you for a jobs in Lagos Nigeria.

Great job bro. Please which software did you use for the wiring diagram ?

This is smart job. Keep it up

You made a mistake why are you still backing your battery with external breaker what of if the breaker trip off it will remain only PV voltage on the system are you know only PV voltage can damage the system without seen battery

Good job

Neat job but the DC cable size for the Battery Bank is too small, cable size for the 3 battery set up should not be less than 50mm-75mm.....because when the battery is drain and is set to charge the cable temperature will slightly increase and might not the able to withstand the charging current of the 3 storage devices

Where was this installed?

what type of inverter did you use and what's the spec of them. Thanks

Waaooo Nice work. But there is no gap between the panels, a strong wind can pulled it out.

I really appreciated your installation, it's great especially the PV support used, is it possible to share with us the lengths of your PV supports and the weight of the concrete blocks used.

I am also an engineer in the solar field thank you

Sono molto fiero di voi bravi fratelli miei

Great work, would be nice to see the schematics of the project 🙏

Nice job!❤

Not good installation not using terminal lugs no quality. Trash bin

Nicet to see this Guys doing the Job with passion

Very Professionally done! You deserve to have many more clients! Hello from Manila!

Beautiful, which country?

Please the pv is it potential voltage or different things

Nice job

Why did u use 2 dc breaker for the pv. Why not go straight to the surge protector then to the breaker which will pass to the inverter. I don't mean to challenge. I'm always trying to learn.

❤ Excellent 👌

Great.We have wall mounted battery as well.

Hi bro , here at the end , all 3 inverter output is connected in paralel to distribution box ??

Good job and thanks

a job well done. kudos. can ds ivem5048 carry a 1hp ac waterpump with only solar panel, no battery?

A very nice layout man.
May I know if your battery do get fully charged. Your installed capacity from the pv 10800w to charge 45kwh battery may take time. Aside you powering your load from it you still can’t harness it all and on a bad weather days. You may not get to harness 2kw from the pv.

Great job

How many solar panels did you installed

Send me the diagram of this connection it’s really professional

Vos panneaux ne sont pas protégés contre la foudre très dangereuse bonne continuation 🤝🤝

Hi guys. Congrats to you! I have a few questions:
1- In which directions are the panels oriented to?
2- Do think 3 strings of 8 pieces of 450w will be enough to charge fully and efficiently the 3 batteries if the customer has hugh load and demand during the day time?
3- Do you know about DC connection bars that you can use to connect the batteries altogether? (it prevents the used battery ports not to burn in the case of a hugh demand from the inverter)
4—What is the length of cables from panels to inverters?
Good work after all!

nice work 💯

Good and clean job.
Congratulation. You don't leave any contact🎉

ok but hy panels face opposite directions?

Bonjour mes patrons
Aidé moi pour les matériaux de 15kw photovoltaïques