Комментарии:
Would it throw a p0300
ОтветитьCould this be responsible for no spark and fuel?
ОтветитьThe jeep liberty pull up to lights, etc.... Would just stall out.. Would start back up and go for a while and stall out again.. Brother in law owned it and nobody could figure it out including dealer. So he laid the truck up for 2 years and I took it over. Fixed it up for the young fella. Ran great for a while then the stall went on it. Young fella checked out quite a few videos and we determined it was either the camshaft sensor or the crankshaft sensor. I said to him well the camshaft sensor is easy to get at but the crankshaft sensor is a bitch and deals with the elements. I said to him which one do you think it is and he said probably the crankshaft sensor. I said yeah probably about 95% sure. Well got under the truck and 4 hours plus later I finally popped it off.. What a bitch!!!!... Worked like a charm after that. Young fella drove it for years until he wrote it off.. LOLOL.. He was OK.....
Ответитьi was driving like 25 mph and all of a sudden my car just stopped going haha
ОтветитьJust replace the unit in 2K Dodge Dakota and you've call accurately. 😮😮
ОтветитьOnly question is what happens if you get all these symptoms but there’s no code that is populating and the check engine light is not showing
ОтветитьThe way u put this video together is epic… ima subscribe even though I barely have vehicle issues 💪🏾👍🏾
ОтветитьMine hard to start in cold intake is that the Same symptom
ОтветитьMy RPM gauge is reading way to high but no engine light could it be the crank sensor?
ОтветитьHi, my car doesn't pull going up hill, no engine codes, Chevrolet aveo ls 1.6 automatic transmission, please assist, poor gas mileage
ОтветитьMy car seems to be rough cold and then runs better when it gets warmer but from time to time it misfires when accelarating. Someone made a diagnostic and got a P1320 code. Apparently its not a coil problem. What could it be then ?
ОтветитьSo how do you know if it’s the crankshaft or cam shaft
ОтветитьVideo was 💯 on point 👍👊guess I’m off to get a sensor I’m 5 for 5…wait shit can’t go no where my car won’t start 😂 keep them videos coming very informative..facts
ОтветитьWould this make the car not start?
ОтветитьHaving the same problem with my 2007 Mitsubishi eclipse won’t start gas pedal won’t work what all the parts I need
ОтветитьI guess I'm going thru the same issue from what 3 mobile mechanics told me what else can It be preventing it to start I was in middle of grocery shopping dropped meat off at home went to finish shopping it haven't started in 6 months I need help bad
ОтветитьThis video was helpful
ОтветитьI work on 2001 Saturn SL2. This car had a permanent code P0446, which was coming less than 1 mi after erasing of the code. It also had very rough idle. I removed P0446 by cleaning all the fuel system, including Fuel Tank, replacing the Fuel Pump, Fuel Sensor there on the top of the Fuel Pump, Charcoal Canister, and by flushing the fuel pipes w/99% Isopropyl Alcohol. I also replaced all the fuel injectors and clean the fuel injector rail. I noticed that there was a plug (made by insect or smth) in the return fuel line (when I replaced the Fuel Filter), and I even think that the plug could be the main reason for the code. The crankshaft Position Sensor was replaced as well on the way. After all of that I drove ~150mi for a new battery installed and went to do State Inspection. The rough idle was still present, maybe it became a bit less, but still rough (especially on cold idle, it would be 1200 rpm). The car passed it, but when I was coming back the engine light came. I thought that is the common thing on Saturns of that type, when some codes come after the State Inspection scanners, but then they go away if you erase them. I've read there is smth w/Saturn computer, which is too sensitive, or programmed not quite well, but that problem w/computer on that car is common. But from that time the code P0401 (sometimes accompanied w/P0300, P0301, and even P0172) keeps coming back. This code is not same as in the film, but the car has rough idling, so I hope on some opinions on this matter, which I would really appreciate. Thank you for the informative film.
ОтветитьYep, my Infinity XJ35 intermittent bumpy acceleration, stalls at a stop light, and often feels like low power. Also my traction control light illuminated after a rough acceleration. P0335 Code . Hope this fixes this because Infinity dealer wants thousands for new CVT transmission with no guarantees.
ОтветитьWill bad crank shaft sensor cause no crank no start ??
ОтветитьGreat information. Thank you 🙏
ОтветитьSpot on brother thanks for the content!!!
ОтветитьThis video was very helpful..Dude is very good on explaining
ОтветитьThis makes me feel hopeful - sounds dead on to be what it is- I was so afraid of timing chain or crankshaft rod issues , even lifter issues bc of the horrible noise - I pray I can make it into the shop and baby a few more miles out 2009 Santa Fe 225k miles
ОтветитьMy veloster is stalling out on me, engine turns off, but radio and electronics remain on. Upon pushing the button and starting the car again, it takes a noticably longer time to do so and usually doesn't on first try. On 2nd try it starts up, but my drive or reverse gears dont work. I have to turn off the car, lock the doors and wait 10 secs, then unlock the doors and it'll start up again. Could it possibly be this issue?
ОтветитьChange ur fire alarm battery buddy 😂😊❤
Ответитьthank you
Ответить🔥🔥🔥🔥 thank you bro
ОтветитьMy car always gos off when slow down driving
ОтветитьM my car turned off the Highway and now out gives me the code for the crankshaft sensor could that have caused it to turn off on me
ОтветитьWhat if you get a crank but no start
ОтветитьYou need a battery for your smoke detector.
ОтветитьThanks!
ОтветитьIn a 2011 cruze they suck
ОтветитьVery informative I got a 1999 Ford fF 250l superduty it done everything listed in video died when it was driving down the road could not figure it out will leave another message if it works out tomorrow
ОтветитьWould it cause absolute zero spark? I got a 91 Cadillac coupe deville with the 4.9. Took me forever to even find what the sensor is called they call it the hall effect sensor. I’ve got no spark. Has new coil distributor cap plugs and wires and rotor all new. Gonna do this and ignition control module and whatever they call the cam sensor I’m gonna replace. This car is kind of a nightmare but I really want it running again for the summer.
ОтветитьThank you!!!! Keep the videos coming!
Ответитьp0122 p1516 p2101 p2119 p2135 i had all this codes and reduce engine power on dashboard mechanic suggested to replace the throttle body i did ..but it didnt fix the issue now everytime i reverse engine power reduce and service traction show up on dashboard any idea what can it beeeeeee
ОтветитьIVE GOT A SERIOUS QUESTION DOES THE VIBRATION GET WORSE AS IT GETS WARMER? I NEED SOME SERIOUS HELP. Thanks!
ОтветитьMy 97 Tahoe at a level speed or a easy excelerate Will backfire
ОтветитьGreat video. The code I’m getting is p0017. I’ve had my solenoids changed and cam sensors. Neither has resolved the symptoms (most that were stated in this video) and CE light still on.
ОтветитьWow bro i just got all my answers in a minute ❤ thanks man i subscribed im on it first thing in the morning 👍
ОтветитьThank you for the info. Very useful.
ОтветитьI got every single 1 of these problems
ОтветитьI like your voice
ОтветитьMine is number4. My question is, do I need to replace the part? Or it’s something I can fix at home? Thanks
ОтветитьThis is insane! I’ve literally been trying to diagnose my 03 Honda Accord V6 with only ~101K, for over 6 months as the symptoms did not appear so frequent, at first (~97k miles then). Things got worse, I couldn’t figure it out and had all symptoms, among others lol (VSA light and brake lights on). Dropped off my car at a shop earlier today, and now I find your video. I might just pick up my car tomorrow 😅 hope to come back with good news!
Thanks for this suggestion and great content!
I wonder If one of the symptoms of causing a code U0401 symptom 71 in camaros when it idles the stabilitrak comes on but when I'm in motion it good and my voltage through the car reads good and with load
Ответить