vPC configuration Nexus 5000/2000

good content, bad video quality

Excellent video. The only thing I would add is how VDC ties into this

Hey - what happens if I go to my N5k-1 and do a configuration change on a FEX port, say I changed configs on Eth117/1/1. Would this change be reflected if I go to to my N5k-2 and do a "show run int Eth117/1/1" ?

awesome job

excellent demonstration

Excellent! Thanks!

Very productive and to the point :)

Thanks! Super good video - just enough info!

Thank You! very well explained!

Thanks so much...

Disregard last comment, i forgot to put "vrf management" after the ping command... DOH!! Please help to respond my other previous comments if you can though.

I tried setting this up with a crossover between the 2 mgmt0 NICs on the back of my N5Ks. I set them with the ip addresses of 10.0.0.1 and 10.0.0.2 with a 24 bit mask. They cannot PING each other. Says no route to host. What could be going on?

And further, would I need to carve out a couple of ports for port-channel on each 5K for management since I would be using the MGMT0 interface for the keep-alive?

Can you shed a bit of light on this for me? I just received 2 N5Ks and 2 Nexus 2248 2248TP-E FEX devices. I have the layer 3 module for the 5K as this will be our new Core. I want some redundancy and I realize the 5K doesn't have full redundancy because of the single supervisor. My question is this... would I connect them in the proper way like this: Connect MGMT0 on back of each 5K to each other for the keep alive you mention in this video? And then connect each FEX to both 5K for failover?

Nice... Thanks

Very Informative !!! Demonstrated In A Very Simple & Easy Way !!

nice demo

Very helpful as i am going on a job and never configured this before

Great Video