How to wire and connect a day/night switch to an LED floodlight load

Best tutorial so far thanks

Thanks

Ive got a problem on our day/night circuit with rechargeable bulbs. When in daylight the bulbs stay on until their batteries drain. On the same circuit are some halogen flood lights, would that have an effect at all?

I have understood it very easily your teachings are very good thank you very much. I also wanna ask if a switch can be added to the day and night switch

Rubber tape then tape it for extra protection from weather

thank you!

Thank you so much I enjoy it

Thank You. This is very informative and well illustrated.

I love you brother... You made my day...
Very simple and informative...
You just earn a plus one subscriber...

How would I connect my existing day night switch to my changer over switch?

Thanks bro

Thanks bro

Thank you so much.

Can the power come from a normal wall switch? (instead of a circuit breaker or a 3 point plug)

Well explained thank you so much .✌️

Loadshedding has messed up my sensor, the lights nolonger comes on like before but only if we've been loadshedded, when the power comes back the sensor works.....

Informative thank you

Using a ferrule for connecting wires which requires servicing/replacement ... I dont think it is a good idea ... have a look at the wago 221 or the wago 224 light connector ... a little on the expensive side but worth it when it comes to replacing the components.

These day night switch are a god send. Thank you for the video....im planning on building a 6m by 20m garage with two t5 led lights inside it linked to a motion sensor.
I watched your previous videos. But haven't seen where you linked a 360 pir with such a setup 🤔. I think major tech has a 360 pir with a 20m range when mounted but unsure about the height. To give me the best range