Комментарии:
Is it bad to replace the two sensors at different times?
ОтветитьVery clear explanation of the sensor function. Awesome video.
Where would the crankshaft position sensor be on a 2003 Toyota Corolla S ?
Thank you in advance.
Got a hilux 1kd engine. Put in a new engine,but it not starting can error codes be causing it from reading the new engine?
Ответитьi had a Citroen C4 Coupe with the TU5JP4 engine 1.6 16v i changed the crankshaft sensors 4 times and i checked the injection spark plugs fuel pump fuel rail all seems good but i was constrained to put the car on a junkyard no one can solve that problem even with new and original crankshaft sensors
ОтветитьThank you. Sounds like every big part of the engine has a sensor!
ОтветитьI need where my crankshaft sensor is located on my 2012 Honda
ОтветитьI’m having a hard time finding my crank shaft position sensor
Ответитьpeugeot 206cc 2l
ОтветитьCan't find it 2000 Plymouth neon
ОтветитьCause of error U1262 in 2012 Honda CRV iDTEC III 2.2
ОтветитьVery informative, thank you!
Ответить1996 toyata granvia 3ltturbo I can't find sensor any help?
ОтветитьHi I have Renault scenic 2008 1.6 patrol I can't find crankshaft sensor plz help
ОтветитьHi there.. I hope you can see my comment. 🙏. is this can happen in all type of cars? like Subaru 2002 h6 3.0?. And by the way, recently I had trouble with mine Subaru as I said.h6.. got overheating. because a hose broke and it split water all over the engine.. in the first time, suddenly stops and then I let it cool down for about 10 minutes and it started again I drove it again for less than 5 minutes and it stop it again and let it cool down again and turns on again, and then I drove it for around 3 minutes I guess. and I stopped that was in the way to work .by that time has 0 water.. that was in the morning so in the afternoon. I proceeded to refill with water so I noticed there was a huge leaking through a hose underneath the air intake.. so I guess I made a big mistake later on. I decided to drive it again without any water... because I couldn't leave it at work So I drove it again for about 10-15 minutes and then got overheating again, but I never let it get to the red line. And then I stopped by myself turn it off let it cool down letting the fan keep working. After about 10-15 minutes when it gets cold I drove it again for about another probably 8 to 10 minutes when I saw temperature was increasing again, I stopped. As I mentioned before never let it get to the Red line... And had it opend switch for fan working. An emergency lights on. So after about 15 minutes letting it cool down, I turn it on again and didn't went on . so right away lights started lower and lower as I said I haved the emergency lights on so,...... So after pulling it with friends help, few hours later,. I make it into the shop where I let it parked.. later on a third day I fixed the hose broken and I started on and didn't want to, so no start. What I noticed right away the headlights didn't turn on and inside dash lights nothing...... Can you tell me if that overheating affects not only the crankshaft? Could affect other sensors, or relays or even the The computer?. Any tips and info, welcome thank you 🙏.......
ОтветитьGreetings, I own a 1993 C3500 7.4 Truck & I cannot locate the crankshaft Position Sensor (CKG).
I've seen references of between Harmonic Balancer & Timing Cover, in the Block above the oil pan, back of the block, or inside the Distributor. I've looked carefully, no loom wires, no port in timing cover, & I replaced the OEM Distributor with new OEM unit.
Vehicle timing set to 4 degrees before TDC. Verified all spark plug & fuel inj.
Vehicle starts, stalls, back fires.
Always buy the oem part
ОтветитьGood info my dude.
ОтветитьPozdrav. Mozete li mi reci gde se nalazi na VW Touran 1.4 TSI, 2007. god.?
ОтветитьCan't find the crink shaf
ОтветитьWhere to find Crankshaft position sensor chevy captiva sport 2013 v4. Thank you. It feels low power? Great inf.
ОтветитьGood information about the starting symptoms that I haven't seen elsewhere. My 2007 Chrysler T&C had trouble starting hot two or three times. I assumed the starter was going. There were no codes. Then today it threw a P0017 and started running bad - almost stalling out every time I came to a stop and responding slowly to the accelerator pedal. Will check the sensor tomorrow, but it seems quite likely. So I'm guessing the starting hot issues can be an early warning.
ОтветитьCan’t find the sensor on my 2011 cube
ОтветитьWhere would the sensor be located on a 2010 Buick Lacrosse CXS 3.6L?
ОтветитьDon't care how sensors work
ОтветитьI need help with my e60. When I plug in sensor the 5 volts goes down to 2.5v.
It's got good 12v power and good ground from dme.
I tried to see any volt drop with a ociloscope. I tried 3 different sensors and 2 different dme.
Out take valves😂
ОтветитьI have a 2016 cord focus 3 cylinder 1.0L I can’t find where mine is.
ОтветитьI thank you for describing the symptoms so detailed, as I have exactly the named problems. Thank you!
ОтветитьPlease, Where can i find mine Audi Q7 4L 2005 petrol engine 4.2 FSI v8? Thanks.
ОтветитьBut ,u know years ago don't need that sensor
ОтветитьCar sometime will stall while driving, but the check engine light doesn't come on. What should one do?
ОтветитьCan these give problems without fault codes?..
Thanks for details from Oamaru New Zealand.
I have a aspen 2007 where is the crankshaft
ОтветитьI have a2008 toyota tacoma xunnernwhere the he'll is this censor
Ответить2008 B7 RS4 I cannot locate my crankshaft position sensor (G28)
ОтветитьWe're is the cam shaft senior on a 2000 QX4 invinjty
ОтветитьI ask you, but you didnt answer, where is the camshaft sensor on my 2010 Nissan altima 2.5 engine?
ОтветитьI guess I'm going thru the same issue from what 3 mobile mechanics told me what else can It be preventing it to start I was in middle of grocery shopping dropped meat off at home went to finish shopping it haven't started in 6 months I need help bad
ОтветитьMy car is very difficult to start for the first time, after about 20 seconds it starts, especially when it is cold. and after that every start goes well, so only the 1st start. Battery ignition coil spark plug has been replaced, what do you think? I would like to help, can it be done by the sensor that only works the 1st time
ОтветитьMy car is getting on but when it's hot & 90% it's shutup while driving or at same place when engine is cold it starts .....what to do plzz help me it's. 1.9tdi engine automatic
Ответить2010 Nissan altima 2.5. Where is my crank shaft sensor ?
Ответитьhi all car has a crankshaft sensor
ОтветитьI need crankshaft sensor of lexus rx300
ОтветитьI can't find where my crankshaft position sensor is in my v70 volvo
ОтветитьWhere is crank sensor for ford rocam is situated
ОтветитьHello i am looking for my crankshaft sensor on my renault sandero stepway ll 2016 model
Ответитьmy battery is getting low plus getting p0851 code and p0335 code in 2010 subaru forester. My mechanic said no need to change crank shaft sensor so he changed only neutral switch. But still issue remains. Thanks
ОтветитьI have a 96 Mitsubishi galant help me find my sensor
ОтветитьMy car idle is not stable, checked this sensor and it was all dirty. No check engine light on, no codes. Toyota d4d engine
Ответить