10 Basic Rules of Column Design - Don't Forget Basic Rules of RCC Column

বাকবাস

Thank you sir, for sharing your knowledge. I am learning from your lectures.God bless .❤

Thanks, I have been studying yr video n like it. Only a bit difficult in following yr accent.

Sir,
Can we construct 2 storey bulding with 4 nos. of 12mm rods in a column ?

22 mm dia will be ?????😮😮

Masha allah i really appreciate you Sir

you did not tell about over lap in columns

You didn’t Mention the main thing that hock of a tie should be curved 135° Angel. 😊

How about 9meters span beam what should be the coulumn n beam

Thank you sir

Dear improve your writing.

I like your teaching you are highly knowledgeable

Useful info thanks

Masha Allah thanks

How to calculate the load.

Is there a height to cross section area ratio in columns?

Thanks for share knowlegde.

Salam sir g da whatsapp number raka plz sir g

What about footing design if a soil is black cotton?

Thanks so much teacher

Peace to you my Honurable Engr. Sir, thank you sir.

Super sir

M20 concrete ratio is 1:1.5:3 or 1:2:4
Which one is correct
2. Above mat how much depth we have to put concrete
3. Tell the reason for failure of column

I love your lecture, very helpful Sir.

best video i have seen so far, thanks

Thank you for sharing.
🙂👍

Thanks For Teaching SIr

I didn't understand the first two rule how do we know when designing where the axial load would be to choose either square or rectangular column?

Very nice explanation and fabulous

Hand writing too small need little bit bigger

🙏🏽❤amazing

Very informative 👍👍👍

Thank you sir, i am from Bangladesh

Great video, very academic. Thank you from Senegal

what is minimum Beam size if 5x5 meter support column residential Building.

Perhaps rule number 11, we should spray galvanized over all outer reinforcement, including stirrups or at least etch and nutrialize metal to point of ph concrete pH will not react as much...
Then we could add number 12, use a coating to protect exposed columns from water intrusion.
Keep up your good work, I have posting on this for years now...

I was laughing the whole time, the accent , the spellings,hahhahah any way good one.

How to do cost estimation for Foundations

Please sir I would like to build a two storehouse only and coloum can this be done

Sir dia b/w 12mm to 32mm but u mentioned 22mm sir ,there is no 22mm bar

Good explanation...

As u told in 9 point

Sir
What happensin colmn if concrete cover more than 25mm in rectangular column

Is clear cover not same around tie of column sir......u said 25 mm from top and bottom and >15 mm from side:....shall we take same or different..

Hi sir plz reply my question,my house only G[G+0], span between 2 columns length 19 feet ,wedth 14 feet , size of colum 9/15 with 6 bars of 16mm rectangler column, all house walls 9 “wall. And first we make walls before slab it is safe or not ? Plz reply

For finding A zone and B zone in coloumn only two floor beams are considered,is not lintel tie beam required to considered?

MashALLAH yr really dua ha apke lia

Thanks

sir,in your 5th rule you said about concrete cover. it means clear cover right. you are saying about effective cover, isnt it?. because effective cover is between top steel center to top edge distance. so concrete cover and effective cover same?

Assalam wo Alykum
Main ne aap ke 10 basick rule dekhe sune. Aap ka shukriya information ke liye. Is liye main aap ka bhi faida chahta hoon. Agar aap bat karna che ya WhatsApp par Contact karna pasand kare.?
Mera Kam main shuru karne wala hun is liye chanal dekh raha hoon.