Комментарии:
You made it easy to understand 😩
ОтветитьVery nice sir
ОтветитьHaving the "stage directions" read out was quite annoying and distracting. If you see fit to rearrange elements, just do so, don't tell me you're doing it like it's something important or relevant to the subject.
Ответитьundoubtedly, the best area to refresh ones power system concepts.
Ответитьthx!
Ответитьperfect. thank you so much!!!
ОтветитьThank you so much for cleared of my doubt
ОтветитьHi, Great video. What drawing tool are you using for your video?
ОтветитьHow to calculate 1/j0.4 become to -j2.5?
Ответитьgreat illustration thank you
Ответитьawesome video. Extremely helpful.
ОтветитьHI.. what is the application program you working on?
ОтветитьNice vid but you could exclude drawing parts and just skip to calculation.
ОтветитьCan you explain to me, how to calculate admittance shunt if we just know the value of the line impedance?
Ответить"Mkay"
Ответитьyou saved me! a huge thanks from Brazil
Ответитьcan you plz upload practical diakoptics tatorials
Ответитьwhat is ieee standard 30 bus system and ieee standard 118 bus system.
ОтветитьThanks for your initiative!! :)
Ответитьplease do more
Ответитьthank you
Ответитьcan u plz upload a video for unsymmetrical faults
ОтветитьAwesome!!! That is clear than what my college teacher said!!! Thanks~~~
ОтветитьHye Genpac.
I registered the forum but yet toreceuve any confirmation email
Does the load connected to any bus (slack bus included) make any difference to the Ybus matrix?
ОтветитьIn a fourth order matrix , why an impedance is not connected between nodes 1 and 4 . (assuming generators at all four nodes) ?
ОтветитьThis is good but I want you to do some tutorial about Load flow...
Ответитьthanks for this video but my quation where we use Ybus and what is befit for study it
ОтветитьThis is a very well done tutorial and thank you for all your other tutorial videos!
Ответить