How To Fit New Body / Shell to Land Rover Keyfob Remote Using Genuine Parts to fix repair

Do NOT lever a circuit board from underneath with a hard metal screwdriver when you can’t see what components are there!!

Really helpful....Thank you from sydney Australia...!!

Tks a million! Without your video I should spend a lot of time trying to figure out everything! Great job guys! 🙏🏻

Thank you, worked a treat. 👍🏻🍏

I have a 2010 L322, which has none of these particular key fobs. Is there another video for those? Thanks again.

Cheers Guys, just the ticket! one part of my original key fob had snapped, so this was a very useful video

Thanks great advice ,I used nail clippers to remove the plastic nib

Thanks very useful

what year is the freelander

You are a National Treasure!

Really helpful video, thank you very much - followed stage by stage to change my old for new F2 fob. Would have really struggled without your clear instructions!

Very helpful video, thank you

After several attempts, I was able to free-up the circuit board from the case. I would not be able to do it without you guys. Thanks 😀

Really useful video Simon. The hard bit is definitely getting the circuit board off the black pins. I managed to grab the ends with needle nose pliers and twist them off...

Please help

What are the Key fob frequencies for the different countries?

Looking to get a spare programmed and want to make sure correct frequency. It is for a L494 Australia

Whew... you had me worried when you were trying to cut the plastic tab when there is an IC right in your path if the blade slipped or cut through...

Is this suitable for replacement for freelander 2 facelift models?

where is the link to buy please

I have to question the logic behind Key Fobs of that size which Fill your pocket and you feel like a Pit Pony carrying that great big thing around with you all day as opposed to the older Key Operated type which is so much lighter and easier in your pocket !!!- Has Technology moved forwards or Backwards ??????????????

Made in China !!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!! Jesus Wept !!!!!!!!!!!!!!!!!!!!

I don’t think you need the superglue or the soldering iron to secure the PCB in the new case - my new case had a pad of foam in the back that secured the PCB on the pins when the case was assembled. I changed my case about 8 months ago with no issues (although with Covid, it hasn’t been used as much as normal ☹️). Thanks for doing this video.

Good work...do you do new metal slide bits though? An “Autobiography” one would be good or one marked “PowerfulUK” might be better!! 😎😎😎😎...there you are, another job in satin finished alloy lookalike stuff!! 😃😃😃Richard

You don’t wanna put an iron near superglue. Stinging eyes.

I had a shot every time you said “right”, I think I’ve damaged my liver 🤣

Hi 🙋‍♂️ 🙏🙏

No need to use glue.
Also you maybe pleased to know the big fat key the early discovery 4s had, that was the same as the 2010-11 RRS and the 2009-2012 l322, you can remove the enternals from those and fit them in these new type keys with just a small bit of nail filling the corner of the circuit board.

I don't understand why you have to glue/hot melt it in. Surely once the other half is in place it can't move?

If you use super glue you will Never get that off again without breaking the circuit board or the remote body pins