DJI Spark's REMOTE CONTROLLER: Everything You Need to Know!

Thank you very clear and solved a few teething problems for me 😁

perfect video bro thnx

Is there a way to use to remote with any other drone or robot available online?

One other videos leave out steps. Your's is better. If you could use a "pointer" of some sort would help with seeing what buttons you are pushing.

hi plz can any one tell me why dose my dji spark wifi saying no date connected and wot i can do thanks

The usb plug on the Controller, is different to the one on the Spark. What utter stupidity.

i cannot change the settings inn the remote controller. It is stuck on mode 1 and I cannot change it . Help

What is the H button for on the front a remote

Bro your face 😆😆

Your explanations are very good. Thank you.

Hi can I use the spark rc with a third party receiver

is it a must to use an iphone to connect with the remote controller to activate the setting ? is it a PC monitor or Iphone screen when you are showing the setting in this video ? I did not see you connect your iphone to the remote controller before you start demonstrating the setting so I thought you are using a PC monitor. Please help clarify. I am using iphone 5 so I am not sure it can fit the remote controller.

merci ************** *♥ ♥

Song?

Everything that I have read both flat sides of the antenna should be pointed towards the drone. If you think about it it makes sense.

Very helpful. Thank you.

Hi Mike,

I have been a subscriber since your early days and have a quick question.
I’m using an iPad with OTG cable. I am using within EU so can I ditch the OTG cable now? I have had mixed results with signal loss recently. Should I turn ON aircraft mode and Bluetooth OFF?
Thanks Mike

Hello friend, I have a DJI spark. I want to connect it with remote control, it does not happen, you will tell me how

Hello good Morning

How long is the lightning cabke

Thank you for this video! I've just found out a couple of useful things 😅

The beginning made me sad LIKE WHAT DA HELL IS GAGAGAGAGAGAGA

Tnx so much 🙏🏼🙏🏼🙏🏼🙏🏼 very very good for my , ❤️

For the most part, I enjoyed your video. I like the part about the OGT cable no longer helps.

I came to your video from searching "how to charge" the Spark controller. Needles to say I bought mine pre-loved. I was disappointed to find nothing about charging the RC. So maybe do one better next time. You're 9/10 & so close to perfect!

Good vid. Thank you.

Mine was low battery in a long time and when im charging, it doesn't light up and battery still not charging. Any advice?

Nice video bro

Yet, ANOTHER VIDEO without the how to charge the remote control

Cool thanks for sharing 😊👍

hi. i did everything. i see the blinking green light on the rc. but it continue blink and bipping.till it get red again.
what i am doing wrong, or what to do?

Does the otg cable still works? 2019

Very nice. Thank you very much 👍🙏❤️🥃

How do I get the app om my ASUS monitor?

Thanks for this vdo
Its vry useful

Hey, I have already subscribed. Sometimes when I connect to my phone the remote disconnects from the drone and I have a cat and mouse game that takes a few tries to get right. Is very annoying to have to bind the remote to the drone everytime. Very time consuming.

my controller keeps blinking red and green at the same time and makes the same noise

How I know how much percent mi controler is

how do you know if it is recording, many time press the recording button but it does not record?

Tnq mick

Hi friend i forget my remote password now i dnt know how to restore that password if you know little help me

Thank you i know all i need to know now

Hi, great video. I have a problem I don't know if its in the remote or the bird itself. I get altitude to 80m and lost signal. I use otg cable. and when flying away i get only 140m far from the remote. Could it be the remote is not working properly ? Yes im in the city, but even in a crowded signales, i think i should get more.

Do you need to link the remote to the drone by that procedure every time you make a flight?

The correct sequence for binding/linking the remote to the Spark is as follows:

1. Power on aircraft and the remote controller. WAIT until the aircraft status indicators (back LEDs) blink yellow.
2. Press and Hold the power button on the Spark for THREE seconds. Release the button after hearing a SINGLE beep. The front LEDs will blink red.
3. Press and hold the Flight Pause button, the Function button, and the Cunstomizable button simultaneously. Linking begins when the alarm becomes a quick single beep after an alternating single/double beep.
4. Then the front LEDs turn solid red after blinking green. When the status LED on the remote controller turns solid green, linking is complete.

How do you vharge the controller?  Do I have to use my phone's charger?  Do i have to use hte drone's battery charger? Do i need to connect the charger to any USB port in my PC? I'd appreciate very much your answer!

great video. I am definitely getting one soon. I wish on the phone app you could operate the gimbal while controlling the drone. This controller has a lot more features that I thought it would.

I broke my charging port and I didn’t realize it until I was trying to recharge the controller I’m sick 🤮😭🤧 I have 77 percent battery left, $114.00 is to steep for just a controller. I’m just glad insurance covered it💆🏾‍♂️🕺🏾but I’m still puzzled by how I made that mistake and I was always gentle when inserting it, DJI should had marked the front from the back on the charger, people be careful when attaching the charger to the controller it can be a costly 💸 mistake! I’m definitely going to mark my new controllers charger when it arrives.

Otg realy don't works?

The antenna are an omnidirectionel antenna.. så the direction dosnt matter.. but you need to fold them out