Klx110L Best Mods for your bike and explained why

Hear me out, how bout we say screw the Mikuni and get a lectron carb for your klx100, they’re expensive yes but from what I hear they are worth every penny, nobody else has a video on a pit bike with one, be the first and show us all the difference they make on a little bike!

What size jets do you run

did you do any fork or tire cutting for the front? also, what size tube are you running in the front?

How do you protect the air intake when you wash it? I know about the exhaust plug but I’m not aware of an air intake protector for them.

Shifter brace …

On the foot peg upgrade definitely need the engine cradle support. I ripped my pegs mounts out of the bottom of the case. Had to tear down the whole motor and weld the case. tap and heli coil the case It was a fucking nightmare

I'm assuming you need a boot and intake piece that matches the 22mm carb? A link/links would be appreciated!

What is the rim size of the back tire? I know you said 12 inch, but is it a 1.85 by 12?

That’s a good idea to reinforce the rear fender. I cracked mine within a month of learning to wheelie 😂

Can you send link to back and front tires

Where did you find tubes to fit the mitas tires?

Mine makes like a gurgling noise at higher rpm or when I’m putting a lot of load on the motor what could that be my bike is a brand new 2022 klx110l

where did you get your exhaust system?

#1 mods for me were HD rims and spokes, BBR HD springs, and chain and sprockets. Those stock wheels are absolute garbage for an adult rider. I ovaled both wheels within 3 hours of riding (pretty hardcore racing). Also swingarm bearings instead of the stock bushing make a HUGE difference on the rear end feel.

The rev box is a good upgrade not because it extends the rpm, but it makes it rev more freely/faster. I have a rev box on both of my pit bikes and I have never had a problem with either of them.

Did you notice a loss of power when switching over to the Mitas Pitcross?

If I’m 5’4 should I get the xr 50 bend or Klein bend? Thank you!

How did u get the stock shifter off with the pegs and brace on.

what sprocket size are you running right now front & rear?