Creality K1 3D printer review

Hello!
Can you share your settings profile in Creality Print? I also own a K1 printer, but I've been struggling with its settings in the slicer for a week now.
Thanks in advance!

it does cool down to prevent plastic from drooping out the nozzle while doing the bed leveling, as it would interfere with the loadcell bedleveling, which is why it touches the nozzle multiple times before, to push away any remaining plastic on the tip.

My God man your ringing is terrible. But you probably printed fast so... Forgiven

Did you print with real nylon, or it was just some mixes like "Easy Nylon"?

On my open chamber printer i forced to use special glue for the nylon, otherwise it just peal off my PEI bed even on tiny prints like washers.

Its doing a nozzle wipe lol. Heat up to melt then cools enough that it can pull any stuck filiment to prevent build up.

Good review! Have you tried an 0.6mm nozzle? Got pretty good results with it, fast and better prints. Also have the stringing especially on petg.
It's funny, I remember your channel from scooter reviews last year, now we both have the k1 reviewed 😊 oh yes, If you havet, put the rooted firmware on it (official) and have a way better Webui and general better access. I love for example mobilereaker and octoeverywhere instead of their shitty cloud app. Greets, Mario

ziuriu kad akcentas kaip pas Minde :)))

Did you buy the camera as an add on or did it come with it?

Nice review:)
And I get all the info what I was looking for about this printer.
Now I can order one for me on Xmas:D.
Thank you again.✌️

Eeeeyyy a fellow wingfoiler! Even more addictive than 3D printers!