Комментарии:
Should do something about the sharp corner, maybe put a rounded bulge (half or quarter sphere) to protect from it coming apart and hurting someone or just someone sliding their arm against the edge.
ОтветитьAapka WhatsApp number chahie Shukriya
Ответить😊สุดยอด
Ответить🎉🎉🎉🎉❤
Ответить👍👍👍
Ответить😮😮😢😢❤
ОтветитьIt’s not that hard just cut 45 turn 90 degrees and cut 45 again
ОтветитьMuito top!🇧🇷👏👏👏👏👏
ОтветитьCakep....
ОтветитьIf you trust these magnets ,you surely don't know what you doing...
ОтветитьGood
ОтветитьThanks, well done, good idea!
Ответитьshow
Ответить❤❤❤
ОтветитьHey, @HandyWelder2.0! In addition to being a cold welder, you're highly adept with the angle grinder. Thanks to you, I'm gaining confidence in using my angle grinder. I've gotten numerous tips and ideas from you. Thanks a Zillion. Bakersfield, Calif.
Ответить...
ОтветитьQué chingon. De verdad. 👍👍👍👌👌👌💯💯
Ответить❤
ОтветитьEl teuco de soldador más impresionantw que he visto.
ОтветитьVery good trick. Thank you
ОтветитьFirst rate!
Ответить❤
Ответить❤good job
ОтветитьQuesto è difficile
Ответитьese es un soldador ! felicitaciones !
ОтветитьGood idea👍
ОтветитьНахуя было приваривать, потом отрезать? Сразу бы показал, да и всё😂
ОтветитьWhy , the two 45 degrees pipes were ok , you only had to shape the vertical pipe .
Ответить👍
ОтветитьVery informative👌🔥
ОтветитьEso es alargar mas el trabajo , los dos prineros tubos estaban bien , solo se pule y se moldea el tercer tubo y listo
ОтветитьВыпускайте пожалуйста ролик на обычный скорости, а в остальном всё 👍
Ответить👍👍👍👍👍
ОтветитьLa bravo magnifique ajustement simplifié mais éfficace quand même,👏👌🙋🏻
ОтветитьPerfeito!
ОтветитьLovely. ❤
ОтветитьPropre et formidable
ОтветитьMantap
Ответить👍🏼👍🏼👍🏼👌🏼👌🏼👌🏼
ОтветитьMuito bom
Ответить👍🏽👏🏻👍🏽👏🏻
ОтветитьWow this guy is really skillful with that angle grinder because when I try and do complex curved cuts, it never comes out that clean so that's why if I can figure out a way to use a holesaw jig instead to do that kind of cut then it will come out better. As a matter of fact, there is a way to use a holesaw jig because the first two pieces can be tack welded securely enough, then put one end into the jig and use the holesaw to cut the circle for the third peace that goes straight up.
Ответитьнихера себе тетрис
Ответить