Does NORMAL GLUE STICK work on 3D PRINTERS?!

Very cool

“Flavour”

bic glue stick (the green cap one) worked the best on a glass bed from my experimentation

What happens if you don’t use any glue?

Where are you got that chopsticks

1M views? Product placement FTW!

Didn’t even know y’all put glue on the plates. I’ve never had adhesion problems 😂

Never thought of putting glue on the pad, I’ve been printing for two years now and never knew this, and my flashforge printer always makes my prints fall off, thanks for the tip!

J

I just use spray glue

The new Bambu PEI plate works great without glue.

I love this because I now know that Pringles makes glue

I’ve been using the elmers disappearing purple for like years now i have no complaints

I don’t use anything. Just my heated bed and it works just fine

That’s gotta reek when it heats up 😭😭

You can, spread it with a sponge and a couple drops of water

I also like sour cream

Are they edible? Please tell me now, PLEASE!

ooeoe

It think it’s 11 because miles morales debuted in 2011