Комментарии:
Thanks for this. I did it a little differently. My roll controls are good enough but my elevator controls were terrible. I didn’t use the rubber bands. I just took the first of the two elevator springs off and just doing that gave it a pretty nice response. I would suggest people start with that and then proceed with your method as needed. Obviously there is going to be some manufacturing variances and it will have to be tweaked differently for each person.
ОтветитьGood vid, but why 360p? 🤢
ОтветитьI do not understand. Have any of you had any problems reassembling the bottom? The 4 screws that hold the rubber bands in place prevent the assembly. So I didn't succeed.
ОтветитьI am going to piss and shit on my Saytek yoke and buy myself a honeycombe yoke. !
ОтветитьMy yoke doesn't have horns so Im not sure what to do.
ОтветитьBro i really love this mod, thank u so much, now my saitek yoke is enjoyable!
ОтветитьAny solution to make it a full turn instead of half turn left and right?
ОтветитьJust change the springs! :-)
ОтветитьI removed the exterior screw mounting brackets (with the large base) so I had to 3d print another pair lol
ОтветитьLovely 😍💋 💝💖❤️
Ответить