How to do Analysis of Water Flow Inside Pipe using ANSYS Fluent | Tutorial

Hello CFD Analysts. Thanks for all the response and support. However, 95% of viewers have not yet subscribed to this channel. Please consider subscribing for more such new CFD videos. Also, don't forget to comment on your favourite part of the video below and suggest topics on which you want videos in future.

WHATS : ANSYS ?????????????????????????????????????????????=EXPLAIN: WILL YA?

Hello Sir..Little curious to know why no inflation layer has been taken in meshing?.Also is it possible to get any material pertinent to flow in vertical pipe?

Very Nice

in my graph after calculation, there are only blue and pink lines. idk why and i can not find my mistake :((

Hi, thanks for the video. There might be a problem defining water as the fluid inside the pipe. You selected water in the "Materials" section. Still, you didn't choose it in the "Cell Zone Conditions" section. So, the fluid inside the pipe is the air, not water.

can i use this to simulate water turbine in pipe?

How to check output values.

Thanx

مرسی

Ansys simulation can put fbg sensor?

Great video, very clear to follow. Thank you very much for this! Hope we could see some more ansys fluent :))

Good!

red color indicates 0.13m/s, not 1.3 m/s. it is in center of pipe.
The input velocity 0.1m/s is average velocity.

Thanks lot!.

pls make a tutorial on airborne dust simulation in tunnel!

Thank you very much for this video, and I wish there was an educational video on the channel on designing fluid flow inside a pipe that contains a narrowing in the middle

you make it look so boring

Dear Sir, I have one question about the in inlet and outlet boundary conditions. The molten salt enter a pipe with 5m lenght and 20mm diameter and 500k . The pipe is made of stainless steel. The heat flux is 800,000kW/m2. So how much should be the inlet flow rate up to we receive the outlet tempereture 800K. It will be highly appreciated when you guide e the boundary conditions in inlet and outlet in such a case. Thank you.

Thank you so so so much

american baba

Is the recent iris xe graphics with the 11th gen i5 16gb ram compatible and sufficient with ansys for low medium 3d simulations?

I need one video regarding streamlines and streaklines

its always showing mesh cannot be generated..... error

such a great video, thank you so much sir !

Very informative!

Gr8👏👏