DOOR INSTALLATION (The Quick Door Hanger) (CC)

BOB SCHMIDT SHOWS YOU HOW TO INSTALL AN INTERIOR DOOR USING A NEW PRODUCT WHICH SIMPLIFIES THE PROCESS FOR THE HOMEOWNER AND NOVICE REMODELER WITH YOUR HOME REMODEL PROJECT. The name of this product has been changed to (The Quick Door Hanger) and may be available at home depot soonI told myself when I started making these videos that I was'nt going to make a video on how to hang a door there's a lot involved in it and it takes experience to learn how to do it properly but I found a new product and I think
it'll give you a fighting chance The product that we are going to use to hang this door today is a relatively new product it's called Quick Plumb for Door
Hanger it's made by Express Products I'm not sure where they're from but apparently they have a website and I
believe they did have a video there and I have actually already watched it this is what they provide you in their package supposedly this is enough for doing two doors although I recommend you go to
their site and take a look at the way they recommend doing it first uh... I want to do it a little bit
different than their directions to try to help simplify the process for the
homeowners and do-it-yourselfers I ran across this product at my wholesaler they were giving them away for free they want
carpenters to start trying to use them and see what they think of them I did hang a couple of doors with them and I
did like the results but there was still some tweaking and
judgment calls that had to be made uh... I kind of went off of what they said and I added to
it and changed the way you use them a little bit where I think it'll give you more of a
fighting chance as a novice or a home remodeler to be able to to do this. As per
their instructions they recommend that you come to about the center of the
hinge you line this little clip up with the
front edge the lead edge of the door and then with the screws provided put the three screws in making sure that
this is kept tightly against the front of the
door as you're doing it. Repeat the process with the middle and the bottom
hinge As per their instructions repeat the
process approximately opposite the hinge side that you've already put on according to their recommendations it's
time to hang the door but I've got a little bit of a different
way I'd like to see you try it directly opposite the clips you just installed on
the hinge side of the door go ahead and install the remaining six clips on the opposite side of the door after you've installed it opposite the
one on the hinge side go ahead and take a pair pliers and bend this flange out straight like
this repeat with the other five on this side
of the door on the hinge side of your door this tab is still going to be bent just the way it was sent at the factory directly opposite enough in all six
locations you're going to have a another one where
you had bent this flange straight-out according to their instructions measure approximately one-half inch in
from your rough opening and put a mark do the same thing on the other three sides coming off of your mark making sure that this
is dead level very important go a head and start making a line and make your line go all the way up and
down the side of the door now that you have the plumb lines on all four sides of the
door both sides it's time to take the door
and put it in place take a level and put it on the top of your door as you see this isn't level what we're going to have to do is we're going to
have to stick a shim underneath the bottom side of that door to make up for this difference here
where it's too low on the hinge side tap the shim underneath the door until the
header says level if this gets carpet you could probably
just cut this shim off and leave it out underneath here and the carpet will fill
the void if this is tile or hardwood what you'll
have to do is cut the bottom of the jam off on the opposite side remove this
shim and let it come down tight to the floor now that you're headers level it's time
to start anchoring the door starting at the top hinge with about the same space on this side
as the other side go ahead and run in your first screw with the top hinge screwed see these three little notches here find the little notch and the spot corresponding to
it that is closest to it and put a mark now coming down to the one below it making sure that your marking in the
same place on the little mark mark it here coming down below it again making sure you mark the same spot
as it was up above which is here then what you need to do is line these
marks up with that plumb line and put screws in these two holes Now starting on the opposite side of the
door same side as the hinge

Тэги:

#installing #tips #prehung #install_door #hinges #hang_door #hang #closet #easy #instal_door #house #level #food #home #To #remodeling #diy #Advice #Do_It_Yourself_(Hobby) #Repair #plumb #homeowner #framing #Framing_(construction) #How #door_hinges #set_door #square #bathroom #door_frame #Installation #bedroom #jamb #Remodel #set #doors #how_to_frame #how_to_build #how_to_hang

Скачать видео