My new DC Power Supply -WANPTEK WPS305H

jel još uvijek radi, nakon 2 godine . pozz

ok... what about ripple? what about electrical noise?

"This way i can be much faster", then it took literally 15 seconds to set the voltage to 3.5V :D

Hi are you still happy with Power Supply?

by mistake i ordered this small one without fines i thought i had the 60v or the 30v10a one at 300watts.. anyway i m amateur and want it mostly for single charge cells and top balace em.. comonly 20/25 amps cells !!! hope with some patience this 150Watts will be ok

Kad si već iz HR. Jel bilo carine?

Gentlemen can you share the brand for your Multimeter in this video and the model number? Thanks in advance!

Hi, I'm not getting any continunity reading on the power bench when I put multimeter probes and crocidile clip together. Any idea why, thanks.

Can you disable the beep you hear when turning the knobs?

Very smart, to hold your hand in FRONT of the display, you will show...

Will it do constant voltage and constant current? Ta

Can you put power in a shorted pcb to see what is going hot and find faulty shorted component?

Hello, does it memorizes voltage and current when power down and off?
Or do you have to set it at each startup ?
Thanks

Wait is this linear or switching psu ?

Will the amperage go down (while the output is on) if the device isn't connected to something that can receive the power? I tried connecting some lifepo4s to a model just like this and the amperage would always drop out to zero when I would adjust it on the output, even though it was all connected to the battery. 🤷 Thanks for any help u can give!

Ottimo ho preso il modello da 10 ampere encoder precisi con regolazione anche fine dei valori

Fantastic, arrive today, it's incredible

I also have the riden 6018 and start to be tired of pressing buttons. Maybe i don t like to have to adjust current initially at 10mA digit
I want knobs. Thanks fos sharing

I bought it! Confused, no manual! says get on line, no link and cannot find! Shipped showing 230volt on cord connection, just as yours is showing, it in 110 Volt connection when showing 220 or do I need to slide over to be 110 volt in America. Are you running 230 or 110volt.
I set it for 30 volt and it lowers the voltage! I want constant voltage and limit the current. odd set up.

Faster than old model looks ok on bangod cost 75 but on ali only 45£ :/

Can you use it at more than 5 amps when the voltage is lower than 30V? For example 10V 15A?

nice

Excellent product