Комментарии:
so, it you have no idea what to do with a 3d printer - mod a printer itself..
I did only those which are really necessary upgrades:
1. motor drivers strongly increase a comfort,
2. heatbed cable holder, preventing its move on a heatbed side (no chain, just a small part which fixing a cable and not allow the cable to break at the weakest point - solder spots),
3. rewiring the heater of the hotend with 2 thick cables, going straight from the heater to the motherboard - no connectors at all!!! Original cable and connectorssss placement is awfully designed. If you have "t0 sensor" problem - 90% chance it is the cable or the connector. 9% - wire connection on a motherboard is loose, or right this connector soldering points broke. The cable to the hotend consists of 14 thin wires, whereas only 6 or 7 are needed, two of which should be at least a 1mm thick. Instead - 14 useless thin wires and a connector that get loose constantly becaus eof the movement, stopping long prints.
4. hotbed isolation mat. reduces power consumption, the bed heats faster.
5. probably another cooling duct. I cant say it changes the world, but sometimes prints are looking better.
part#20 link is failed . How to get the part#20 stl?
ОтветитьThank you. I have downloaded the tool rig.
ОтветитьAre they compatible with anycubic mega pro? or is it necessary to scale?
ОтветитьFolks...I am stunned how almost no one is commenting on how terrible the print quality is on every part shown. Absolute beginner garbage with most every flaw you can name...stringing, layer lines, banding, elephants foot...etc. These prints are absolute garbage. The designs...awesome. But who shows garbage quality prints like this in a tutorial?!?
ОтветитьExcellent Job!
ОтветитьSorry what was the sensor switch called I can't find the link on Amazon. I asked before but lost your answer :)
Ответитьthank you this is amazing to have for my old "legacy" mega S...
ОтветитьReally cool! Super excited to get my Mega S and do some of these
ОтветитьThank you
Ответитьcan you show us how to make good lapses like in the video??
Ответитьbravissimo...ottimo progetto
ОтветитьSome of your upgrades there is no thingiverse number, can you provide the files?
Thank you
In part 18 Hotend Cover and Fan Cover where did you get the fan and if you printed a mold for it to be attached to the hotend?
ОтветитьHi, is this Stuff also Compatible with the Mega Pro?
ОтветитьI can't fit my hotend cable through the chain. How did you do this
ОтветитьWow, you did a good job. I like it and will try to repeat! thank you!
Ответить