Комментарии:
great idea, thank you!
ОтветитьNo glue on the groove to stop this problem resurfacing???
ОтветитьQue tontería
ОтветитьJust kick it into place with trainers or slippers on.
ОтветитьSkirting looks fine 😂 might want to scribe it first.
ОтветитьWaste of time and tape. I just use my suction cup that I used to set my ceramic tile when I do my lvp if I have to move a plank like that I just put the suction cup on it and pull it.😊
ОтветитьNice
ОтветитьJust kick it back together
ОтветитьThat’s some thin stuff. You could snap that with a knife lol. We only use 10mm cork back. Good luck sliding those in place.
Ответить😂😂😂🤦♂️
ОтветитьJust use a rubber mallet and hit
ОтветитьUnfortunately it’ll only be a matter of time before it unsnaps again, best bet is to redo the floor with plank ends closer to the wall
Ответитьits from using a garbage floor
ОтветитьI'll be damned😅😅😅😅
ОтветитьPri bar will save you about 15 minutes
ОтветитьYou didn't have to do it in that way. You could have used a suction cup and slid that up in the groove,
ОтветитьJust use double sided tape instead.
ОтветитьYou forgot to add glue
ОтветитьJust stick a piece of tape to the floor leave an extra ft untape wrap back over the top of the block.. then tap no need for hot glue
ОтветитьI have never been turned on without knowing what a guy looks like and thinking how smart he is before.
But here I am.
Use mallet add glue next
ОтветитьLove how the trim no longer hides it
ОтветитьHonestly so smart
ОтветитьNo hot glue I have ever used sticks like that
ОтветитьBruh just kick it back smh
ОтветитьWhy not glue it while your at it?
ОтветитьYou could also just build it right
ОтветитьThat's a broken butt joint.
ОтветитьProTip #1 :
Turn off your comments so theses out of work floor guys won't annoy you...or me.
Brilliant
ОтветитьKick it with your foot in seconds dont faff about like that
ОтветитьYou could’ve use your barefoot or your sneaker too much work buddy
ОтветитьNow its 1/2” short at baseboard
ОтветитьBrilliant! Thank you for sharing this!!!
ОтветитьDo the same with your foot
ОтветитьGap along the wall NOW
ОтветитьOMG 😲
ОтветитьIt’s still vinyl
ОтветитьYou need one of them glass suction grips
ОтветитьSize 9 Air Jordans work well 😂😂😂😂😂😂
ОтветитьHarbor freight suction cups
ОтветитьOr do it right
Tic toc morons
Wood glue in the joint and Steel toe work boot. Kick that mofo into place
ОтветитьYeah I could have fixed that with one kick of my foot you wasted time and materials that was a easiest fix you could find in a house and you went way overboard fixing it
ОтветитьEntire floor has bounce to it. Shit install from the get go.
ОтветитьWhy didnt ya fix the plank with glue itself? It may happen again?
ОтветитьInstall it correctly the first time.
ОтветитьSwift kick with the bottom of a shoe grip and that would be over with no damage. Done it many times. That’s just pure over kill
ОтветитьDo you know how to fix a dent I have
ОтветитьDo a little glue in the joint as well
Ответить