How To Build Your Own Custom GPIO Boards for the Flipper Zero!!! ‍

I need to see more videos like this esspecialy this channel has been producing the most content about flipper zero you might as well dominate.

It would help to add or link to at least a bit of motivation to the description / intro: what can you DO with the named devices on a GPIO for a Flipper?

Do I need a script (if yes, how I do it) for that or can I just connect it to my flipper

How do u add software to it/use it ???

Is that a sprite or creality direct drive ??

It’s always good to see the pros mess up like the rest of us. Never feel like you should scrap a video like this. They’re my favorites.

"You just need to make sure you don't bridge things...."
Feverishly proceeds to aggressively punch in a mountain of solder and bridge some valleys.
"....I don't even care about that!"


...... .... ..yup

Thank you for doing this video, Question could I use the flipper wifi dev board and add on modules to it?

What are you using to clean it when you say clean it?????

Hello! Thanks for the good video! I saw you soldered the wifi chip GND to the 2nd pin which is not GND on the flipper, but the SWC... Is that OK?

Is there a diagram to all the wiring you are doing?Kind of hard to see what goes to what with the time lapse

58 and getting into CyberSec, any advice?

so I can hook up an nerf and an esp to the same ports and they work fine? so no switch or anything just solder both boards to the correct pins?

I appreciate videos like this. It illustrates common mistakes and shows us how to fix them. Its like learning from a real person and not a perfect robot!

The flipping of the pins made me lost for the rest of the video. Is the 3rd hole the ground?

what pcb board is that

Your on a completely different lvl than I. I have so much too learn and am very impressed by your skills . Im still running original firmware and api mismatches everytime I update on q flipper it makes me have reinstall everything. Is there a better way? I noticed after reinstalling some things they were updated or ran better with less furihal crashes.

Great video again!

can I connect nrf 24 or esp32 wroom to the 5V on the flipper?