Using SD Cards with Arduino - Record Servo Motor Movements

Can someone explain how the mosi and miso actually function please? Or is it just input and output?

Sd.h 是否考慮增加掃毒功能，否則未來單晶片不知道會不會跟電腦一樣中毒，以上純屬個人觀點

very good

Thanks very much for this video!

As a possible partial answer that I asked below (about half an hour ago), I just found a vid from someone else, which might be the answer to my own Q.

Apparently, there might be a line of code that mentions "interval". That might be the answer to my question?

Thanks

It's incredibly clear how well you explain things; you're quite intelligent. I wonder if you've registered any inventions yet?

How to access these data in the SD file from the PC? What kind of interface it requires?

I'm not entirely sure if this is the appropriate place for my inquiry, but I'll proceed with my question nonetheless. I'm interested in knowing what it would entail to create a device similar to the Sony HVR-MRC1 Memory Recorder. It seems like it shouldn't be too complicated to construct a device that incorporates a Firewire port, a small screen, a handful of buttons, and the ability to record incoming Firewire streams onto an SD card. Could someone kindly provide me with information regarding the necessary components' costs and the complexity of the coding involved? Thank you in advance.

My sd card module has a difference. It says MOSO instead of MISO. Is it the same?

Hello, I have followed the process.. SD card formatted with FAT32.. Wiring was Checked.. MicroSD card Inserted..

But it says Initialization failed.. what is the reason? Please help..

This video is absolutely a work of art and I have a lot to learn when teaching students and creating content. Thank you for the work you do. What's the best way to support You? 😭

Really good video, thank you. Methodically explained and demonstrated, subbed.

Thank you so much for the clean explanation ☺️

Could I use an SD card module to replay audio files on Arduino and not use a DFPlayer module?

Always great explanations.

Thanks for as always making such a rich content and explain things with such a detail , now my question is , Can we have *.txt file created and load info ( such as DHT sensor readings ) in it and at the end send it via WiFi or Blue ? then at the end delete the file for not taking whole a lot of memory ? All done without including SD memory card and all other accessories and extra work that comes with it ?

I have a project which requires reading data ONLY from a SD card into a static array in the setup(). I only require this to run start-up. This uses a total of four digital pins on the Arduino which I would like to re-use later in the sketch for different functions. Is this possible?

How do you overwrite instead of append?

Thank you very much for your time and for all your efforts.