Trianglelabs Matrix Extruder Review: printing TPU

You can do the same with the stock extruder - at least I do

Cool! Super quick for tpu. I bought the BMG wind after following your review on your site. Cant wait to install it and print TPU faster!

Have you measured the weight? How speed you could print without suffering from ghosting etc?
I usually print PLA and PETG, does it have any problem with low and high temperature filament?

Nice video, which fan duct did you use for the fan?

In the review you state "There are issues with the print, but they are caused by the lack of cooling. I will re-do the test after I upgrade to a 5015 fan. " Have you upgraded yet and are the stls for the fan mount available anywhere?

Hi very nice video
I saw Trianglelabs Matrix Extruder installed on the Artillery Genius with customizing board to the original ribbon cable -- can you share the board? any link to find it ... Thx

how many mm retract while print TPU?

At what speed was the retraction and distance?
Did you use coasting as well?