Комментарии:
Absolutely a Phenomenal video! I knew most of it but your simple teaching abilities cleared up a few things I wasn't clear on. Helped me out a lot. Keep up the great work!💪🇺🇸
ОтветитьJust replaced my hot end and nozzle. Been looking for a comprehensive tuning video. This checked al the boxes. Thank you for taking the time to put this together.
ОтветитьWhy use a larger diameter nozzle? What is the benefit and is the sharpness tradeoff worth it?
ОтветитьWhat’s up dude…I’m only about two months into 3D printing and need a little help with my Neptune 3 Max…yeah, I bought that behemoth! LOL I jumped right into the bigger projects right out of the gate. I’ve printed a Predator’s mask…yes, one to look like it came off a 7+ foot alien! LOL A Jason Vorhee mask, and a Deathstroke helmet. They all look wonderful, but when printing smaller pieces I’m getting blobs in small areas in only some prints. Any ideas why?
Ответитьdo you load the filament in al that then mark the 120mm?
ОтветитьHe has a drawing of everything he has ever printed somewhere on his body!
Ответитьthe ketchup demo is PRIME
ОтветитьAt the end of all those tests you need a new roll of filament 😅
ОтветитьIs there any way u have some cura profiles I can copy bro I have the Neptune 3 plus and have not base profiles to go off in cura new to this and going nuts but this video is a big first step thanks
ОтветитьCan u help me? I have the neptune 3 max. And its printing slowwwwwww. Is there a way to print faster. Im trying to do figures. In pieces.
Ответитьmy extruder was like 3 cm under extruding xd
ОтветитьOne day extrusions will not be science fiction
ОтветитьThis might be a me thing but I'd really prefer lav mic audio over this studio voiceover the maker community has adopted. It takes away from the raw experience and I prefer less of a compressed bass heavy audio. Just trying to give some constructive feedback tho cause I really enjoy your content.👍
Ответитьhello, great video, thanks for sharing that topic :)👍
Ответитьmy experience with the neptune fdm printers matches...they are very close to dead on from the factory
My ender 3 v2 neo on the other hand....
LOL my printer N3 plus got 88mm only 😱 now time to fight with bed lvleling
Ответитьthis would all be great if I could get my elegoo Neptune 3 to connect to my laptop
ОтветитьI like the content but goddamn man, if you had thrown the money you spent on body mods at a proper psychiatrist...
ОтветитьWith the e-steps, I gotta say you have to be very, very good at using vernier calipers to make that kind of measurement to within 1mm accuracy, even averaging several runs. Speaking personally, if the measured extrusion is within 1mm over a 100mm run I'd totally just leave it be.
ОтветитьSuper helpful guide. Thanks for the detailed explanations, and an even bigger thanks for letting me know where I can get some ketchup 😁
Ответить