Комментарии:
Ben ! on peut faire mieux !! voilà voilà
Ответитьvery nice this
ОтветитьHex is better especially on multi stranded
ОтветитьHex dies are the only way
ОтветитьPlease tell me it comes with complete lug dies with stamp cast markers.
ОтветитьРеклама пресса или чего другого?
Ответить"Точка" не очень хороший обжим
ОтветитьТакой аппарат у нас стоит почти 200к, пипец.
ОтветитьMore of a hex crimp man myself..no loose strands ...gota love the lack of arm ache at the end of the day though with the hydraulic crimpers.
ОтветитьI prefer hexagonal crimps.
ОтветитьПресс говно!!
ОтветитьThats a nice little toy you have there
ОтветитьЛадно, пока с гидравликой побегаем.
ОтветитьWhat is that tool name for peel cable?
Ответитьthat tool is too clean
ОтветитьIt is not the best kind of crimping
There is the hydraulic crimper with dies .
나이도 어린놈이 이빨로 물어 나뗀말이다 이빨로 다했다!
Ответитьi use the clamp twice starting from the bolted connection down as the tip has stretch properties
ОтветитьVihainen robottilelu ei pidä siitä, että häntä kidutetaan.
Ответитьthis was like a god damn porn movie with the close ups and pov
ОтветитьÖzgüven kablo türkiye
ОтветитьHex crimp always much neater
ОтветитьPerfect electric
ОтветитьGood PPE 😆
ОтветитьAny idea if/when klauke are moving to the Bosch 18V platform?
ОтветитьThe crimp was too light.
Ответитьvery good job
Ответитьсамый правильный обжим.
ОтветитьХорошо на верстаке это делать.
Ответить😮
ОтветитьIndent crimpers should be banned
ОтветитьThat looks awful, hex crimp or nothing.
ОтветитьAre these indent crimps allowed? I was taught as an apprentice it must be a hex type due to risk of overheating at the point of compression
ОтветитьMy.. what a big Klauke you have!
ОтветитьI will stick with hexagonal press tools
Ответитьজিনিস গুলো কোথায় পাওয়া যাবে
ОтветитьÖzgüven kablo
ОтветитьOnly one press?
ОтветитьKabloya dikkat turk mali
ОтветитьThat looks like a rather shitty crimp. Those strands directly beneath the point of pressure, will be deformed way too much.
Ответить