Make a Flex Sensor for Robotic Hand and Arduino | DIY

Very linear sensor 30, 75, ...1000 😂😂😂

nice video! why use pencil? is it okay using pen instead of pencil?

Doesn't work.

how it works with just aluminium?

Is this aluminum foil paper?

bro both are cardboard

Next time on our channel diy brain surgery to double the efficency of your robotic dick.

My servo motor is just making some noise and not rotating please help me......

Money saving one

1 craft take petrol and thermacol plastic make it plane$
negative printing
For shine hydrogen pera oxide lime juice
1 craft for you
Make
Cotten tinner fevicol 1st dry full,
Cotton tinner White fabric color dry full.
See that paper is getting wet or not
All the best
Then
1 broom 10 mud sag to grow potatoes or seed
Earn
Fizzer and hair blower fan for water. Enjoy
👍flash stamp machine
Wifi application for msg
Roll with scrap printer machine
Heat sink

Wow, what a creative alternative!

instead of hot silicone or solder can i use tape?

freaking brilliant !

It didnt work for me

do you have to use it as an analog? or can you also use a digital pin

Wich pen i Need to use?

Can you please tell me the resistance range it showed from flat to fully bent position

kodlar yok gözüküyor linkte

sir pls comment how you checked the values of flex sensor

THANKS FOR WASTING MY TIME

After seeing your construction of the sensor and looking at images of manufactured one it is apparent to me that two designs are radically different yours is two resistors each connected only at one end; the other one resistor connected at both ends. Go figure.

The values fall when the sensor is messed with in any way and then rise again regardless afterwards. What is wrong?

the values from mine are just completely random.

Bro that was awesome! But how it works? How its resistance is lessening?

Isn't this essentially a bendable capacitor?

The value of my flex sensor is fluctuating. In serial plotter it forms a wave like structure. What can I do?

i know that what are you trying to do. but, i don't understand that when you bend your flex band, how it will be creating close path between aluminium contact? and change in resistance is too far from your device.

I am not sure but was it a capacitor flex sensor?

Keşke türkçe altyazı olsaydı son kısmı anlayamadım

Will it work in your robotic arm

thanks!, this is exactly the thing that I was looking for, i will be back in one year

You make us fool if you work seriously then your subscriber's will be 1M

It's not working

Bizimkiler hariç herkes burada.

Do you colour in one side of the paper or both sides with the pencil?

Can this thing get bended for more than 5000 times?

I may be out of the line here, but I think the graphite on the paper works as an electron transmission medium, when it is bent, the amount of surface area for electron transmission changes, and that changes the resistance. But as I said, I am presumptuous

How does value of resistance change with the curl of the paper

What is the principle of this thing, change in capacitance??

does it work as real flex sensor because a flex sensor cost is nearly 10$ .

Am I missing something? How exactly does this flex sensor work? The test circuitry works when both wires are directly connected without the flex sensor but from the looks of it, the flex sensor doesn't do anything

Thanks

I cannot but wonder who gave those 88 downvotes and why...

Not working

Quick question: I saw another video that made flex sensors with aluminum can. Does it differ, like Will one work better than the other and why?

It is not working at all even with servo motors

what is that value of sensor? how did you get it???