VLANs and Interfaces | Introduction to Juniper and JNCIA Part 3

hi i havejuniper on my eve-ng... i think its different or old model os.. theres no ether-switching after family. please help

Dear Sir, I can not create van id that means this command is not working on VM " set vlans vlan-name vlan-id 10 " can you help me what issue?

Hello. What are the benefits of membership ? Do you have virtual labs to practice ?

This is what i was looking for, thank you so much, i wonder if there is JUNIPER course to buy? Plz contact me or guide me how to buy it. I deeply need to learn Juniper system.

Today I had to configure data & voice VLAN on the same interface. I spend 8 hours tried every method I could search in juniper resources, but it was a failure (couldn't get any worse). Now after watching this video twice I think I know what to do.....thanks

You are an absolute god send. Thank you so much for these videos.

Great video all of them hats of for your way of explaining!!

Excellent job!!! Well structured, good audio quality, clear video and rich contents.

Any comments on configuring bridge-domain for mapping vlans to irb's in MX? Otherwise they don't work at all like you expect. This got me at first (coming from old school IOS). Good work on these series. :)

Hi, I love your content keep it up.
You said along the lines. "If a Primary or Preferred are not configured/selected then the lowest IP will be automatically selected".
My question is, selected for what? the Primary or Preferred.

More informative than Juniper learning bytes.

In cisco
Interface gig1/0/1
Desctiption User
switchport mode access
Switchport access vlan 10
Switchport access voice vlan 20
In Juniper ex2300?

I watched two ads completely before this video start😂... Love you bro.. Keep it up..

Thanks for your time. This is very helpful

2nd

First