Design AND Print your own PRINT IN PLACE - Feat. Creality K1

The teardrop hole design significantly weakens the part by increasing "notching effect" this is not a good idea. I designed my own print in place hinges and printed them vertically instead with a round shaft, layer orientation is not optimal but runout is great and I used PETG so layer bond is pretty good.

Great topic, thanks 👍

Thanks for the video! There are surprisingly few videos about both designing and printing print-in-place models :)

Very good informational video, thank you.

Elephant foot is slicer/printer issue and should be eliminated there not in the model.