Комментарии:
Good video, just a question though, how much force did it take to undo the large end of the ball joint
ОтветитьGonna do the same here 😅 Thanks for this video 👍🏼
ОтветитьInstead of thread locker I'd put some copper paste in there to make sure it comes out easily next time. I've never had one of those loosen itself.
ОтветитьНе понятно как рычаг стянули с шарового пальца.
ОтветитьNigga please!
ОтветитьExcellent video 👍
ОтветитьThe chrome socket says 14mm because it is for removing spark plugs. Its a spark plug socket. They usually have a rubber bush inside to grip the top of the spark plug to help with removal once loose. It's labelled 14mm because the thread on the spark plug is 14mm wide, but the spark plug will have 21mm flats to remove it.
ОтветитьIt's better not to use thred lock, because next time you need to unscrew the ball joint, it will be a big problem
ОтветитьWhat are the symptoms of a bad ball joint ? Does the wheel shake a bit ?
ОтветитьYou a buy a new wishbone for £25/40 complete with ball joints and bushes. Easier to fit than a new ball joint that can cost £15
ОтветитьVery nice video, well done, kudos for the jack idea,
ОтветитьGood video
ОтветитьThank you!
Very calm explanation.
Good video,but may I suggest just taking an angle grinder to the ball joint nut, just cut it clean off 😊
Ответитьon the last part why do you need to bend it? is it ok not to bend ? looks like messy looks
ОтветитьThank-you
Liked & subscribed
👍👍👍👍👍👍👍👍
Just replaced both ball joints on 2015 Master. The driver side was left hand thread and passenger side right hand and both held in place with a lock tab.
ОтветитьJust subscribed, I like how you get things done, even with limited tools 🫡👍🇮🇪 (Ireland)
Ответить