2 ways to drill door cylinder lock.

Wonderfull, i did it myself and it was a piece of cake. I finally succeeded to change my room cylinder. Thank you

Hello, where can I buy lock cylinder marbles?

I humbly thank you, kind sir! Worked perfectly. I must note I went for the keyhole itself with a larger drill bit at first.The lower second drill finished the job with whatever pieces were left, so there was nothing to pull out.

Thanks now everyone can found the neighbor's kids on my basement

I didn't drill my lock out in the end. I was able to snap it but this video is helpful regardless. My drill is old and kept getting stuck as soon as I tried to go. You need an 18V drill with a good motor. My rubbish old 12V drill wasn't good enough.

Works, I used a battery powered drill, but because of the lock size I have used a smaller heads, you need though a small tool to pull out the springs. The safety goggles are also a must

Music sucks

Thanks a lot you saved my day. I would say my house.

I was so upset after moving into new property the where no keys for couple of locks.

I trick worked😮

What a brilliant video, very informative. Just bought a new house and the garden gates are locked shut- now I have a solution!

Why do you have to hit it at the beginning? Can't you just drill?

Do I need to use bigger and bigger drill bits or all one size from start to finish please?

helpful thanks

i made over $500,000 with this one simple life hack!

I tried it but there's some kind of anti-drill feature, I can see and feel a spring-loaded claw looking thing at the end of the keyhole. All the pins are definitely out.

I drilled it and it will rotate but not unlock

What's that tool that was used to indent the cylinder prior to drilling?

Very good

Call a Locksmith, have them open it without a drill

what about an anti snap lock, if you have one fitted its the same routine but will take about 3 hours each side. nothing on you tube about this.

Fajny kanał bardzo przydatny pozdrawiam

How do you get past the hardened anti drill pins?

Thanks for sharing. Where's the second way tho?

Thanks breather! i like it

Thanks my brother , you just saved my weekend!!!

Nice video, gave it a big thumbs up!!
(That song sucks though!!)
Thanks!!
🤣🤣

sick music choice!

if you are a locksmith please dont do this

That a hard way

Thanks for this incredible video. I've been locked out of my house for weeks

I'm really grateful for this video, helped a lot

i got a problem that the key got stuck while twisting and is not completely inside the key and i can't pull out, just the lock is not completely unlock the locker and just the key is a little bit pull out, but got stuck, i don't know if i explain well hope to get some info

Excellent video

All my tools are inside the house 😂

बहुत शानदार प्रदर्शन

I'm on my 7th pin and the door still wont open :(

I just opened my stuck lock like this. It worked out really well. Thanks for sharing

Even though the pictures were easy enough to understand what you were doing, I would much rather hear what you're doing and why you're doing it instead of that obnoxious music, I had to turn the volume down the whole time

I

that bloody music was so annoying

Why didn't you snap it?

This guy is clueless that's not how you drill out locks he was lucky they were low security cylinders.

It's a wrong way, You can still used it no need to drill and replace it again. No no no

This is good. I tried this one.

Could have gone without fn music

Thank you very much man. It helped a lot

Is there a way to determine how deep the lock is if I don't have the original key? Can I use a toothpick to just feel where the keyhole ends? Is there a risk of drilling too far?

What's the small tool called that you use to put inside the lock & get it to open ?

Thank you!!!!!