Setup Your Own LED Strips // WLED Hardware // Part 1

can you please cable manage your desk setup 😭

Hey Ryan, I dont think I have enough power for my LED strip, I think, as they are not lighting up. Your math for my setup is 60 ma, 300 pixels (total) / 12vdc = 216000 is that watts (looks very high)? My wall plug is 12v 2A (input 100v-240v). btw, Im in the UK!

This is a great video! Unfortunately I only watched it after picking up an ESP-32 at Microcenter today. Your PCB looks great, have you made an updated version for the 32?

Thanks for the great video! The second part is great too.

Good work. You need to slow down and enunciate. Hard to follow you. Enunciate.

Is it possible to run an RGBW strip off of a 8266 controller? If so what is the pin setup? I want to run it with the WLED program. If not possible with WLED, which program should I use?
Also, some gave me an RGB strip but it has 4 terminals (R,G,B,+). How do I set that up?

When I use the esp32, do I need the extra resistor board too? I watched a lot of projects on yt and with the esp32 they never used an extra resistor. Also, I looked for bigger projects with 600leds+ where they connected the esp32 and the leds directly to the psu and just connected the Data wire from esp to strip.

Is there any start effect that allows to turn on LEDs starting from buttom to top and when all LEDs are ON it stay ON?

I am trying to figure out why you're using the resistor even in your blog post diagram it's not clear what it's for

Noob to 3D printing and Octoprint. I wanted to get some help getting started with WLED and found your series on the subject. The information you presented makes it look easy. Waiting on my PCBWay order before ordering the rest of my supplies.

I'm looking for the power adapter piece you soldered into the board, it isn't in the kit link in your description and I'm not having much luck. Could you please point me in the right direction?

But apparently NOT the ESP32-S2. I've been working on loading firmware into one for about 4 hrs and it seems it's not really supported.

Looks terribly complicated

Can you make a video on how to connect wled with Hyperion? I’m trying to do this.

Informative content!🙌

Hello, can you help me to have some esp32 with diferent sectors and to work acording some motion sensor... To use wled?

I need for my home (aproximativ 40 m)

I will offer 100 euro bonus If you cane hellp untill the end of project

This is incredibly thorough, I got addicted to Home Assistant last year, and am just getting ready to start my ESPPresence and WLED projects. Excited for this series and keep up the good content!

I have no idea what you are talking about

In its me Liam and thank you of saying thank you

I made it this far. Hi Liam!!