Connecting Stepper Motors to CNC Breakout Board BOB Parrarel Port Wiring + MACH 3 Setup

Hello. I have the same breakout board and connected the x axis the way you did to test. I setup Mach3 the same was as well, but I get an "External E Stop Requested" error and cant figure out why

Good job....and thanks for your videos👍

Does the rnr motion card support linuxcnc?

Hi, can you please explain why the breakout boards needs to be connected with the USB too since it requires 24V supply?

does this kind of mach3 board with lpt should run on windos 32bit? thanks

Which laptop and window u r using for parallel port

I buy this mach3 board and connect to my window 7 64bit processor computer but nothing happened is this board work on 32bit processor

PERFEITO SEU VIDEO PARABENS

Driver dobiera się do mocy silnika?? Widzę tam inny zakres Amperów. Masz może wiedzę o doborze Silnika krokowego[closed loop] w stosunku do wagi, którą dźwiga? Potrzebuję zrobić ramę XZ. Na osi Z będzie chwytak do detali max.2kg. Myślę, żeby oś Z zrobić na wózku i listwie uzębionej na profilu alu. Czyli 2kg detal + chwytak + konstrukcja, może z 6-8kg.

can we connect parallel port to USB cable for mach3

good evening I bought a set with stepper motors with drivers all bought on amazon and it's called rattmmotor after the wiring and configuration it doesn't work for me and I don't know why could you help me please?😢😢😢

I have the same board but not getting connected to my computer? Please let me know. Which driver to be install for this card

Thanks for the content, my stepper motor is already moving, from some references finally bob and tb6600 work.

hey mate, do you know where to get the dll file for this board, i wasnt sent and having trouble trying to fins, i have dll for previous rnr motion board, was sent this one which i didnt order, ill use.
cheers

Thanks for the content, I'm learning a lot, could you clear me a doubt regarding the 36v power supply output for the drivers, it only works with 36v? I'm looking for a similar board that has 12v and 36v but I don't think so, I'm from Brazil and the site that appears on the board doesn't send it here, what do you recommend me to use? Thank you and I love your channel!

my laptop doesn't have a parallel port any suggestions?

I have the same breakout board. And it works but interestingly when I use multimeter to test continuity between pin on the breakout board and the pin on the parallel port, there is no continuity. Do you know why that might be?

Will work without Mach 3 license

Umm, please use the convention, Red for +, black for -. It might cause smoke if someone does not catch that your colors are reversed. : )

can you give me circuit diagram

Nice video sir

Great