4 Channel Ultra Micro Receiver

Tim, in case you're interested, the original AR64 receivers are still available on Aliexpress. What I like about them more, then about this 4-channel ones, is that AR64 built in ESC can control both brushed and brushless motors, apart from obvious 2 additional channels.

Hi Tim, do you know if the aeroscout will be on sale on Black Friday? Thanks

Legal,gostei.
👍🇧🇷🇧🇷🇧🇷

Tim. I was wondering if a person could use that micro reciever in a sport cub s?

My f949s rx will not bind to my flysky i6 transmitter. The rx flashes at one speed and will not stop flashing. Can you please help.

Hi Tim thanks for your reply but how do I prepare my receiver for binding there are no buttons on it. Its a wltoys f949s receiver sorry to bother you again.

Hi Tim thanks for your advice but it didn't work. Does it make as its flashes 2 flashes stops then 2flashes off then 2flashes and carries on like that .thanks again.

TIM PLEASE HELP ME. im converting a guillows kit and i am runing it on a 1S power suply with a brushed motor the one i was using was a 716 motor and it seems to not have enough poweer to fly my model weight is 3.9 oz :( a little heavy its model 307# . what should i do ? im using one of thoes 4 chanel micro reciever that has a built in speed control for a brushed motor . im not usre if it will take a brushless motor . any advice? i just ordered a slightly bigger brushed motor the 820 one hope this will be enough but idk . any tips you can give me please?

Hello I have a Spektrum micro unit I can get servos working but cannot seem to find connection for motor it has 2 connectors for the micro servos but foxed by motor .John

Just to let you know the Micro Spektrum servo board motor connection (RX62-H) is located on the rear of the board next to where the battery wire is soldered on ,it has to be soldered also. These are available from :servo shop:

Put a red dot on the plug… red dot to red dot! Ahhhh

Hello. I have the dx5e and the rx42d and I have been able to get them to bind but the esc will not work. Documentation says it has auto lock function but I can’t seem to get it out of auto lock. Any ideas? I am new to RC. One of my first planes

Hey Tim.... I see two connectors on the board... does this mean I can run dual servos? I want to build the low wing plane you showed earlier.... unfortunately I sent Stevens aero this question and they never responded. Thanks for the great videos.