Using Deep Pour Silicone Molds For Flower Preservation - How To Encapsulate Flowers In Epoxy Resin

Amazing results with the right mold + deep pour epoxy! Your selection & placement of objects appeared very good (esp after the reveal). Q: can you (or did you) use real flowers with this process?

What brand top coat did you use

beautiful

How can you fix those later lines? They are visible and that would bother me as a customer. Is there a way to maybe sand them down or will they always be visible?

Why not use a UV Resin ? Im beginner 😅

In the semi-side shots the layer lines are clearly visible. I have found that this is caused by allowing the layer to fully cure. If you pour when you can still leave a fingerprint the layer lines are MUCH less visible

Great video! You covered things which other creators have never covered I truly appreciate all of the information. I will definitely be watching you again. Thank you so much.

Thanks for the great vid!
I'm going to have a go at doing this with flowers from my wedding!
Is the sanding and top coat necessary every time? Why is the final layer not good enough?

Wow gr8 job ❤

Turned out beautiful

That's just beautiful!

It looks amazing...
I have tried to preserve flowers in adeep cast too, however my stuff kind of all just bubbled up to the top even higher than the mold :( any suggestions why?

Beautiful 😍

Wouldn't it be better to place tape on sides starting from the bottom up so if it does drip down the sides it won't get in between the layers?

Have you ever made a block like this and included a photo? Any tips?

What process do you use for drying your flowers???

what is a table top coat? How is it different?

Hi such a beautiful block, great work, thanks for sharing 😍 ❤️ xx

What epoxy brand you use?