Комментарии:
Thanks for the awesome video. I wish you happy printing!
ОтветитьTruly an inspiration. Just what I needed today. You always make the best print videos.
ОтветитьI suggest you look at the VZ bot before calling this high speed. 😅
300 was good several years ago... also, you're going to need a lot more power to go fast and get rid of ringing artifacts. I would recommend LDO steppers. And 48 volts. Do 72 if you can, but 48 is much easier to hit.
"ULTIMATE SPEED"
Vzbot with Stock Tronxy 24v 2WD here. so the Slowest Version.
And i do 25k/600mms. with 48v and AWD i coud to 50k-100k/600mms easy.
Which stepper to replace with for X/Y - in case the stock ones are insufficient for holding torque on microstepping etc ?
Ответить10k/600mm sec with my stock QIDI X-MAX3, and it's slow by comparison to other printers. But it's great to see the FBR2 getting some loving. :)
ОтветитьWhere did you get the mount for the Biqu H2?
Ответитьso do i need klipper to install the bl touch to this printer or can i do it with the stock config?
ОтветитьI'm struggling with my printer and could use advice. I just assembled my reborn 2, and this is my first 3d printer. It seems to bind when trying to bring the bed up and the motors start making a weird noise. Kinda like when you set a drill really low on the torque and the fastener stop and the clutch disengages sound. I don't know if that is a good description. The rails feel kinda difficult to turn, so maybe i assembled it wrong, but I'm honestly not sure
Ответить