How To Limit the High Speed Setting on a Danfoss Variable Frequency Drive

Thank you for sharing your experience and knowledge .

When i change the frequency and press OK it goes back to the settings saved before. Could this mean the drive is locked to do changes?

Sir how to increase the VFD brand HEDY industrial automation thank you

how do u set the cut off point for the pump you are running to leave a certain amount of volume in a tank so it dont suck it dry. thank u

Hi ! can you tell me if with this setting if you can save the pump? because every two years the pump burns. Thank you

Hello sir, Is this type of speed settings process can be used in all types of VFD s.
Thank you.

If I limit current, will the vfd trip or just adjust the speed?

Worked on a lot of different VFD'S. Danfoss is the best. Great tech support. On 75 to 150 HP Danfoss old VLT 6000 & Newest FC200'S had trouble numerous times drawing high current say above 54 Hertz. Found out that too many room dampers were either closed or only partially open. Would place motor in bypass and it would draw over rated motor nameplate amps. Also had higher ampere where bearings were going so was told to ramp max speed down until repair could be done.

Hai
how to change 50hz to 60hz frequency when it is in auto mode

Hello
I just replace a TR 150 drive with the VLT FC 102 but I cant make the motor run to max speed the manual says to check the output limits on 4-13 but it doesn't show on the display. It only shows 4-12 and 4-14. Any Idea on what am I doing wrong? Thx