Комментарии:
on 98 f150, located in cabin and is 5 amp, test KOEO
Ответитьcan this cause eyesight to come with check engine light on 2019 forester?
ОтветитьSo all This time I thought that checking a fuse was just supposed to be one side
ОтветитьMan I can't believe I wasted my time watching your video your fuse blew for some reason. You didn't even explain it all the way, you gotta turn on your ignition, show us the fuse doesn't blow again. You gotta find out what made the fuse blow
ОтветитьThanks
ОтветитьI replaced the Cold thermostat sensor
ОтветитьMine runs for awhile then stops and turns off
ОтветитьYou failed to mention any prerequisites prior to using the test lamp/probe. Is the engine and ignition off/on? Do you do the same test for every fuse by sticking the pointed probe end into the small metal part of the fuse's top (there are one on each side)?
ОтветитьBoy thank you so freaking much, I almost replaced the alternator out of exhaustion with not finding the problem. I'd tested the standard fuses but not this 🥴🥴🥴
ОтветитьI’m a newbie so this may sound dumb but here it goes.. is the ecu & ecm relay the same?
ОтветитьMy windows want let down and my sun roof want come open
ОтветитьI just need to know what fuse number it is that is the ECU button on 89 Cadillac DeVille what number
ОтветитьDoes anyone know why my ecu fuse won’t run off a 10 but will run off a 15.? It is meant for a 10 amp btw and 10 amp is not blown
ОтветитьI don't have a fuse in place for my ecm . When I install a fuse for the ecm the car won't run......
ОтветитьWhere is ecm relay located? I'm getting p0690 code. I have replaced my battery and alternator. I'm still getting the same code
ОтветитьMy fuse isn’t blowing it’s not lighting up with test light at all in certain fuses. Fuel injector 1/2 crank 3 ect other fuses like windows ect work? Any help
ОтветитьWhat if I change fuse and it still does not light up? Which direction should I go from there?
ОтветитьWhere is the ECM battery located?
Ответитьwhy is it keep burning out pcm 2016 chevy cruze
ОтветитьYou blow a fuse on the ecm you have bigger problems
Ответитьy did it blow n the 1st place
ОтветитьTraslate in spanish
ОтветитьThanks u i literally gave myself a headache, I switch batter an terminals was on opposite side an forgot an hook an let it touch an blew fuses smh but thanks u
ОтветитьReally cheap alternative to a anti theft alarm. Or if you dont want anyone using your ride.
ОтветитьI have 5 volts to my ecm and pcm fuses on a 2005 silverado.
Could it be anything but my fuse blocks?
2CARPROS, what do you use to Flash program various ECM, PCM, TCM modules?
ОтветитьChecking my control module and the cables. I heard the cables could be a issue on a captiva, making the module bad.
ОтветитьThat was great
But you did not say why fuse is blown?what cause it to blow ?
It may blow again later
Why is my truck killing the batteries if I do not turn it on 1 day I have had this happening for months now.. I have taken the battery to the auto parts store several times and they tell me the battery is dead. Once the battery is replaced it works fine then after not running it one day the truck will not turn on. Ignition is damaged due to theft.could that also be an issue. Thanks in advance for the help.
ОтветитьHow about a 99 Honda Civic , at first the car was over heating replaced radiator no over heat , but car stalls or have to be at high rpm to get in to gear
ОтветитьWhat if the fuse doesnt light at all and have a no cranck condition
ОтветитьI found out when the ECM fuse keep's blowing out you have a short, you need to find the short , and this fuse is used for a lot of other things so more then likely you need to make sure that any of the wire's are not getting heated by any motor part's .And yes one big problem is fuel pump having a short too.
ОтветитьI changed starter, alternator and battery and it’s still happening... my scanner says “lost communication to pcm/ecu” (08 Malibu) no crank,, no start
ОтветитьAll these years u jst taught me how to test a fuse 💯
ОтветитьI need a diagram for a fuse panel on a 2005 Ford Freestar
ОтветитьIt's all about ECM. controlling freak unit which mean additional crab and rip off money . In order for any vehicle to start it must have fuel, spark , good fuses and crank/cam position sensors. I am experiencing different issue, that the fuel pump and engine sensor fuses has
no current on it like all other fuses and I am suspecting that the ECM. no more communicating with crankshaft sensor and that why my vehicle crank and own't start !.
am i supposed to disconnect the battery when i replace fuze ?
ОтветитьIam in saudi Arabia. 2007 Suzuki petrol van was not starting no spark and eng light was blink.I have power in coil.plz give me solution thank u
Ответитьi have a 2004 Toyota prius . I Replaced the Mechanical hybrid synergy pump now the car wont go into acc mode to start . where would the fuse your talking about be located on the prius ? help .
ОтветитьI have a 2004 Grand Prix GT with 285,000 miles. A few days ago I had a misfire in cylinder 6. I bought a new coil pack and replaced it and the car works fine for one day. As I was driving home that night the car stalled out as soon as I got to my driveway. The car never ran hot. I tried to start it up but nothing. All electrical components are working except the AC fan isn't now. There are no codes showing. And there is no sparks coming from none of the coils now. I've checked all the fuses twice and they all are good. As a precautionary I changed the crankshaft sensor and the ignition control module and still nothing. What do I do next? ECM PCM or Timing Chain? Help??
ОтветитьMy computer resets everytime I turn the truck off I was told bad ground or a bad memory fuse I can't locate it. HELP!!! 2004 GMC Sierra 1500 4.8 liter 4 x 4
ОтветитьIf you remove the ECM fuse, will it turn off the check engine light?
ОтветитьWhat if we replaced the fuse, but it continues to blow out as soon as we turn the key on?
Ответить