Homemade mobile gantry crane

What welding machine did you use

0Hii

What type of beam did you use? Can an IPN200 beam be used for a load of 2 tons?

Can you list the software you used?

nice.

Now build a fucking bandsaw and stop using a cutoff wheel

hello, could i also get a copy of your plans? it looks like a great build!

Great job. It was really inspiring

That Metal is pretty rusty to mig weld on without cleaning first

Szia! Gratulálunk szép munka. Épp ilyent szeretnék csinálni. Még kaphatóm a tervet. Köszönöm.

Nice job!

👍👍👍👍👍👍👍👍👌👌👌👌👌

Never weld on rusty metal!!!

Expert use of angle grinder.

What was the cost of build

Nice job. Would you send me the plans? Thank you

That plate to I- beam weld looks like it's quite cold, no penetration! I wouldn't trust it!

Le agradezco si es posible enviarne los planos gracias

Excelente construcción muy práctico y funcional muchas gracias por compartir sus conocimientos y experiencias

I congratulate you for this excellent work, can I have the plans with the dimensions, thank you

Desen cu dimensiuni?

Hello Milan,
An excellent design and execution. Would it be possible to obtain a copy of your plans, please? I'd like to build one just like yours.

Супер🎉🎉🎉🎉 дякуємо🙏👋

Great build video. Nice work.
Thanks for sharing.

nice job

Looks nice. Great video. Oh....I'm the 151st comment on the 151st day of 2022. Hmmm

Чётко 👌👌👌

F ft check baby t t g v armature t g no n 9 armature. no armature
typically. .j
' armature 6 armature typically. baguette ny uhh hugger
8 ع ت و armature

These welds will hold just fine. But as you get more practice, you will turn up the amps a bit to get more penetration and more consistent weld profile.

hello, u have any link or recommendation to buy that wire rope?

well done!

Can anybody tell me how its work

Please what is the name of software you use stress analysis? Thanks

Hi.. can you please tell me what specs is for the beam ( inches on deep, inches on flange and the material thick... I need build one 20 feet long and 12 feet high and I need use one beam with 4 inches flange but I'm not sure the thick of the beam and the deep that I need to buy and the square tubes thick.......thank you

Great job my friend. I wish i knew how to weld in order to build this. But i am inspired by your work.

Great job. I'd like to build this.

Bill needs braces from the centre to out side legs stop swaying when moving or pushing it it may be fine just i would put braces in Plastic wheels i would use steel wheels as plastic wheels will pick up any small stones or steel bump bump just like a super market cart
You made a great job of it just me i like too make sure that it wont fail as you know some people will over LOAD units like this
Take care and all the BEST Barry NZ

Nice system for elevation, best I've seen.

I guess if the weakest link is the plastic wheels you should be well within strength of the metal should the welds hold even w no prep

OMG plastic Wheels!!

Painting over Rust lmao

BEAUTIFUL WORK VERY FUNCTIONAL.

szia,kitűnő ötlet és másolandó!

Price

needs braces or it will split --wheels wont take much weight wheels should be steel not knocking it you have done well just thinking of safety factor

Any chance you would share the design ?

جميل جدا احسنت عمل متقن اهنئك تحياتي اخونا العزيز