Комментарии:
amazing it's a high level skill
Ответитьvery very cool. Straight to the point and well made.
ОтветитьWow , that's what I want to see diy TT.
ОтветитьMe encanta ese trabajo, soy psicólogo, pero la tornería y los trabajos en metales me fascinan, muchas gracias por compartir
ОтветитьWould have like to see the burrs left in the thread form being addressed, rather than just a cut shot to the finished thread form.
ОтветитьSUPER 👌
ОтветитьThis is so great and precisely done.I love this job
ОтветитьWhat kind of steel did you use ???
ОтветитьNice Hobby, expensive part.
ОтветитьWonderful 😊 explained
Ответитьliked your video, i've made taps that way outta O-1, what kind of little spindle do put on that tool post? One thing, you did not seem to need a relief angle on the front end? easy enough to do on belt sander free hand, thank you!
ОтветитьVery bealtful
ОтветитьI bet this is not the HSSE or HSS Co5. I think this is even not the regular HSS. Moreover I have some doubts it is a 9Cr.
ОтветитьQuestion, please, how do you attach the envelope to the brushes of the Freeze?
ОтветитьGood job good luck always
ОтветитьGood job
ОтветитьGood result ! Congrats ! You could relieve the back of the thread a bit - it doesn't cut there and it'll make it easier to push through the metal.
ОтветитьBravo meseriașule asa o sa încerc și eu bravo la fel folosesc cuțite lipite dar trebuiea sa ne areti strungu pe care ai lucrat bravo
ОтветитьWarum macht man bei Gewindebohrern keinen Führungszapfen?
ОтветитьSicuramente il maschio taglia Bisognerebbe però controllare la qualità del filetto con un tampone Iso passa non passa non provarlo con un semplice bullone anche se poi ovviamente dipende dalle aspettative
ОтветитьNice 👍
Ответить