Getting started with STM32 built-in USB DFU Bootloader

how to do in python?

I have an STM32F4 with both BOOT1 and BOOT0. I guess the BOOT0 is just as this video (tie to supply when programming). But how should the BOOT1 pin be pulled?

Can I upload code to the same processor over and over again this way?

Can i do with blue pill (stm32f103c8t6)? please answer me quickly

For what it's worth to save someones time: it seems that Dfu File Mgr and DfuSeDemo are deprecated on windows 10, it's recommended to use the stm32CubeProgrammer in USB mode.

The circles you have to spin in to just get one thing working is criminal.

I need a Mac version of the software too

like the worst describtion I ever heard. I dont work in any way and its Frsky itself. be fucking ashamed

I have STM32F407VET6. I can upload programs in DFU mode, however when connecting the board in USB Serial mode, STMCube shows this error:

Timeout error occured while waiting for acknowledgement.
Error: Activating device: KO. Please, verify the boot mode configuration and check the serial port configuration. Reset your device then try again...

How can i fix it?

sir, i have only connect boot0 pin to vcc to enable dfu mode.there is no another process is required

can it also copy or read the code from the STM32 chip?

Hi, we are working on a STM32f407VGT6, we want to upload VESC bootloader. Do anybody know if it is possible?
We succeed in uploading all the files but VESC tool does not recognize it....

what is the jumper setting for stm32l152 discovery board to go into DFU mode

how do i excess the dfu file manager?

How to program read-out protected device from bootloader over DFU?

really windows 98 !

Can i enable read-out protection using dfu mode after programming?

where can i download the bootloader

When STM soft will comparable with MacOS?

I have a STM32F429I-DISC1 and I want to activate the USB port CN6, it's why I watched this tutorial but it doesn't work. My computer doesn't detect this port. Despite, I connected the pin BOOT0 to VDD and BOOT1/PB2 to GND thanks to jumpers, then I reset but the DFU port wasn't detected by the computer and the screen of my STM32 became fully white. I have the feeling that the solution shown in this video doesn't work for this type of STM32. So I would like to know what I am supposed to do to make it work.
If someone knows, thank you for giving me the answer.