Комментарии:
thank you !
ОтветитьThank you!
Ответитьthank you so much for this ;D
Ответитьusing it for a few years and now I want to upgrade and I'm happy I did that.
ОтветитьHello Mike, how would you apply a png-logo image on a tank of a 3D Harley Davidson motor. The png is partly transparent and the tank is very curved in all directions. Where the transparency is from the image, the metallic car paint, which is applied on the tank, should be visable. Hope you have a solution.
Ответитьcobain renderr lahh bangggg ko punta gw pas d render jadi acakan lebel nya
Ответитьgood job
Ответитьthanks for sharing! excellent
ОтветитьTHANKS FOR SHARE
ОтветитьThx mate its works
ОтветитьI need to do the reverse. I have a 50 gallon drum and I am putting a pipe into it, off-center, and I want to cut the hole precisely... So, once I extrude the pipe cut out of the drum, how do I print a flat representation of the hole, that, when printed, will look a bit like a teardrop shape?
ОтветитьThankyou soo much!
ОтветитьGood
ОтветитьI fucking love you man.. i was trying to figure out how to do it.. i waste hours and hours.. THANK YOU !
ОтветитьThank you so much for this. I have been having problems wrapping images around edges and cylinders. Please keep it up.
Ответить