Комментарии:
Most PD-USB power supply chips drop the power to 10W per port if multiple ports are used. If you need QC for every port you will need an independent chip per port on the trigger board
ОтветитьIs this good for powerbank
Ответитьis the module working on,,,input DC 20V/4.5A -> output PD Type C laptop ??
ОтветитьWhen using usb a the module switches to 5 v it said in the institution’s
ОтветитьWhat does the less indicate? If i may ask?
ОтветитьIf i solder a battery to this circuit, can i chanrge and discharge with this module or is it only one way?
ОтветитьIs it hot when used with qc 3.0 or 18w?
ОтветитьI have power bank 5v with usb step up 12v. if I use step down 5v 4a can it work?
Ответить12.07 plus voltage loss equals 11.5 to the module. So at best the module was using 9V PD.
Ответитьwhat can i do for a 12v motorcycle battery to get at least 2 amp???? is sooooooo slow whit my xiaomi reminote 9s, it dont charge just i can get a slow discharge :( helppp
ОтветитьCan this be used as a replacement for a cellphone charger? assuming daily use
Ответитьim powering this with 12v but i keeps on and off..do i have defective board?
Ответить19V output charging smartphone with need 5V. This PCB can regulate volts whiting explode dispositives?
Ответитьdoes this module support fast charging vooc 3.0 oppo/realme?
ОтветитьDo you know what IC it using?
ОтветитьDoes it have a galvanic isolation from the PSU?
ОтветитьCan it charge fast on "one plus " phones?
Ответитьlast week i buyed this module but work only 10 watt when i use more than it is shut down and very hot
ОтветитьNice module charger... 👍👍 Any 3D printing for this module? What CTP2?
ОтветитьA great review. I bought some of this from Ali. Thanks a lot. :-) Five thumbs down from hate people, I think!
ОтветитьI think I will get this to convert my portable 60w solar panel 18v-15v DC to this
ОтветитьHi how much input Voltage and Amperes Needed to function it’s PD charging.
ОтветитьI saw my Mac switch to 100w charging while using this module with a high power C to C cable. I'm not sure the module could handle 100w constant load but it probably has internal thermal throttling but might be bad to heat shrink wrap it and cover the chips without a heat sync first
ОтветитьDude you are my hero for posting this. Super good info!
ОтветитьCan it boost from 12v to 20vPD?
ОтветитьHi, what you used as the power input source?
ОтветитьHi, thank you for your video. Could you tell me if I can use this module for a DIY powerbank? Is it bidirectional?
ОтветитьCan it charge which support quick charge 3 device
Ответить50c is very hot, especially considering it is free air right now. Think how hot it will get if it is concealed inside a vehicle behind the dash or enclosed in some housing without fans.
ОтветитьCould you test it with xiaomi supported QC4 or QC4+?
Ответить