What does a capacitor do?

After doing this do we need to remove the capacitor and discharge it, or did it already get discharged when the led finally turned off?

Finally a video that doesn't have to do something complicated to explain it and just gets straight to the point. Thank you.

Sarvan video for me special

This video could have saved me a lot of time 30 years ago. Alas..... kids today don't know how good they have it.

how is this different from an inductor

Sir you are greatest

Thanks!

Amazing,

Ultimately I got this❤

Best explanation

Hi Sir, I have a question. For touch screen switch and some smart light bulb, when you turn off the switch, the light bulb only dim and not completely turn off. but when a capacitor is added between the live and neutral cable, the light bulb is completely turn off. Able to illustrate what is the reason behind that?

Very good explained and informative. Thanks.

hey, how do I make a delay turning on the led?

This video is so good

Thank you so much!

Short and sweet

Resister value ?

How do you determine what capacitor size you need?

🫡

I'm assuming you're supplying DC current, my question is how does DC keep flowing and keeping the LED on if there's no physical continuity in the capacitor?

is it flowing through the resistor while connected and only using capacitor once power is disconnected?

Can u plz provide the circuit diagram of this entire work

Simplest explaination of capacitor

For what we need it?

Very helpful, thanks so much

Very useful video. Thanks

I learned something new today

help me on this please!what type of capacitor do i need to buy in order to give a spotenious fade when i turn off the switch on a 12v 100watt halogen car lamp!

I want to ask, how can I maintain the arduino r3 running at 12v for 2sec while switching to alternate power source.(Note: I have the main power source producing 12v and a battery producing 12v too) the power module circuit is yx850 power failure system. There's a a delay in the module when switching

Wooah, that was a short crash course that was absolutely amazing

Will this have same effect for 120V AC

How much voltage to connect with led

what voltage of battery did you use?

Excellent breadboard set up.

Wish I could give two likes.

Thank you

Very interesting and informative.

what about what does a capacitor do in a flasher circuit?

Thank you.

thanks 👍

Short and clear.. 👍👍👍👍

Your teaching skill is exceptional!

Thank you.

Hi there! I want to use a capacitor to stop a 12v small led flickering . I aimed to 16 v capacitor but not sure what UF to chose. Do you think 22 UF or 47 UF will do, or should I get a higher UF ?

I want to install Smart WiFi Switch with my AC do I need to install Capacitor or I can just wire the wires directly with the Switch. Thanks

Very much helpful. Can you tell me what volt-capacitor should i use for a 12 volt LED strip? I will replace my Yamaha keyboard's display backlight(ccfl) with LED. I will take the 12 volt power from any voltage regulator located in the power suplly board inside. Thank you

This video was so helpful, thank you!

Great explanation, the best I have seen for a capacitor.

Came from a gmail

Thanks for this great explanation!

You are a marvellous teacher