Комментарии:
Thanks for the info. Respect.
ОтветитьThanks inside of the tire worked
ОтветитьIncredible.
I tried and nothing, for now I'm putting air in the tire.
Try an air hammer?
ОтветитьThank you for your advice. It helped me.
ОтветитьRIP the ones with a flat tire
ОтветитьI tried all this and everything in comments no movement.
Last resort called a mechanic mate, he said you have to belt the wall of the tyre front INSIDE out with a big hammer, 4 hits and it was off, it worked for me. Give it a go.
Will this work if the tire is flat ???
Need to know asap - work vechicle
2x4 and shaking the truck was the only thing that got that tire off. Can't believe it worked but very grateful for the video and idea!
ОтветитьThank you I’d like that makes perfect sense I’m out here with a heat gun heat gun gets up to 1100° but no luck yet I like your idea better I’ll let you know thanks
ОтветитьTo remove a front wheel I loosened the lug nuts and used the steering to pop it loose.
ОтветитьOn the fronts you can loosen the lug nuts, start the truck and rock your steering wheel back and forth to loosen wheel.
ОтветитьLift up the opposite side of the stuck tire. That way you put the weight of the vehicle on the stuck tire at an angle
ОтветитьIt didn't work for me so I left the lug nuts loose and ran it back and forth on a concrete drive stopping fast. When I was done two nuts were tight the other two loose. The wheel was now loose and came off easy.
ОтветитьI found your video because my 19 f250 rear wheels are stuck. I will try your method tomorrow. This works great with a floor jack but I'm wondering what happens with a flat on the highway. That could suck.
ОтветитьThanks, that was very helpful. I used wood and it worked perfectly.
Ответитьworked for me thank a million
ОтветитьHey Shawn,
I like your attitude and detail to your care for your SD. Carry on sir.
I'm surprised you are lifting your truck with the differential. I use a highlift jack at the trailer hitch. Good luck.
ОтветитьDid you put anything on to prevent the wheels being seized on again.
ОтветитьWhich rotation method do you use on the SuperDuty?
ОтветитьTake a piece of wood, clean no nails, about 3ft long and a dead blow hammer. Put cloth over wood that comes in contact with rim and give that wood a good smack with dead blow hammer, it will move. Get 5lbs dead blow hammer. Peace
Ответить