Комментарии:
Your All video is very helpful ..❤❤
ОтветитьThank you so much!
ОтветитьWhat’s the first thing to do? Thumbs up! because I’m 100% sure always will be a great video
ОтветитьLol, the illustration showing an output module going directly to a motor made me laugh a little.... In actuality, it's going to some type of device which CONTROLS the motor, likely a starter or a vfd or soft stat ✅😊‼️...It could be a servo motor though too, to be honest.
ОтветитьHow l can learn your online course.Send me link
ОтветитьHey ,how do I get the realpars app?
ОтветитьRealparz is the best
ОтветитьThanks for useful information..
ОтветитьPretty good.. What is the name of the tool used to create this video?
ОтветитьOn the project I'm on now I've run into an issue where I was regularly unable to go online with a ControLogix PLC until it was restarted, even though Studio 5000 could see it. Yesterday I found the cause: there are 24 other PLCs that were essentially performing a DDoS attack on the poor EN2T card with messages!
ОтветитьThanks for another helpful video. I say " Keep It Up " ❤
ОтветитьAs always 🔥🔥🔥
ОтветитьExcellent explanation
ОтветитьLovely Tip and Trick thank you somuch
ОтветитьThank you for sharing valuable trouble shooting information
ОтветитьReal pars is the best organization on automation education. You guys are on a league of your own. More troubleshooting please.
ОтветитьTroubleshooting by using Trial and Error method! You must be out of your mind. Using the logic mindset to trace the error and solve the problem.
ОтветитьPlz make more videos on this topic
ОтветитьAmazing tips for PLC troubleshooting 101..very good solution
ОтветитьThanks for teaching
ОтветитьYou make wonderful informative videos..😍
Keep it up😎