Make your own GPS SMS Security Tracking System

Have you done any videos on sending encrypted SMS/MMS via WiFi to/from a security device to a home security system like HomeAssistant? Another idea would be to send/receive SMS/MMS to a cell phone without having to pay for another SIM card?

Nice project but you can buy these units for 9$ complete nowadays.....just hook up 2 (or 3) wires and go....it is also contained in a nice small waterproof package...

What about if they come with a gps signal jammer like they do in most cases?

How to get suitable project box?

OMG, what an antic bike (Simson)? Anyway, another interesting video from you, thanks.

Would be useful to have the option to send an SMS to get GPS information immediately, this way you can manually request the location of your vehicle regardless of whether it's moving or not.

I will put this in my Vodka maybe my Pet Russian will stole it

yeah fuck my S51 just got stolen... Police says they can't do anything

So, did this ever save you from theft?

The only problem here is no independent battery was used in case the main battery is disconnected.

Dammm you could of buy a gps and gsm

OMG that is a simson! I have not seen one for ages

If there is a two way communication then device can stay dormant until not needed.

Policee gpss

Ritesh gps banglore

Heimliche Engelbert Werbung

When you recognize that this could also be used as a bomb

Do SIM5320 work everywhere? The modules I've seen online are for specific regions e.g SIM5320E for Europe etc.

Your tire is flat :D

Thanks for video, very useful

You would have to leave it in the "on" state when you park and turn it off when you ride it.

let's make GPS device that can be tracked over GPS server

You do realise you've posted your latitude, longitude and phone number on the internet along with details of how to steal your bike?

radiation level specification of the shield? is it safe?

Very good
But can you use call
At first call biek on secand call biek off
The sms is high cost

"Direct" SMTP (port 25 iirc) is often blocked by your ISP to refrain mailicious packets (that have been forged by hand) to get to your computer... if this isn't the case you might receive an email from the official amazon email asking for credentials (scam), because there is no client-side sender ID verification by default. (you can send a "manual" email via command line that can have any email adress you want, that's bad.)

Pretty sure that's why the mail didn't work on your board. It probably doesn't pass the packet to a centralized and verified authority...

I am thinking about making such device for my bicycle as it was stolen a few days ago from a place secured with cameras which I thought to be the most secure place to park a bicycle in town but looks like it. My only regret is not making this call earlier.

gps + engine cut off plz

I really wish this could be revised for sending texts over GPS without the sim card for areas without cellular signal. Also for a smaller form factor.

Great scott is really great.

What kind of code is this ?? C#?

Ehhh... wouldn't something like:

// Setup where my Home-Location is:
ACord: CONST = 123456.123456
BCord: CONST = 56789.56789

// Check for my mopped, is it still in my Home location?
while true do:
aCord = do.the.GPS.Stuff
bCord = do.the.GPS.Stuff
until aCord != ACord || bCord != BCord do:
break;
end

// Running Permanent verbose Alarm stuff. Call SWAT!
while true do:
send.mail("Hey, I am driving! See me @ {aCord + " and " + bCord}!")
end

do the same job? That way you wouldnt need the whole Vibration Sensor Setup at first, and you also will get a grip on your shopper if someone just load it up
his Van and steal it without much Vibration. Sure.. you would need to add some space, in case you dont park in the exact same location like yesterday.
But for now, I would consider this, if you build that again.

Super Sache, nur kann ich so was nicht 😪

Very nice project. What would need to change on the amplifier / comparator circuit for a 3.3V MCU?

Could you update this DIY project with 5G and LIDAR ? That would be legendary 😉

Hello sir. I followed every steps and even used the same components but i can't seem to lower the default baud rate from 115200 to 4800. It says "couldn't find fona". Any help pls?? I used softwareserial in changing the default baud rate but it doesn't work. Any kind of idea would be of great help. Thanks

What is the relationship between cost per blade of grass per watt by man-hours wasted and equipment amortization rate?

Nice to have everything you need to make anything you want.

Dude you could have paid a neighbor kid to mow in the same day for 40 bucks. Amazing engineering, no common sense.

Quien diría que 5 años después se inventara el airtag y una app para geolocalización

Imagine if someone doxes themselves by playing around with GPS modules carelessly

How you bypass Jammers?

buen proyecto

Back tire a bit flat 😉

I like the movement sensor on your tracker with adjustable sensitivity.
, Is there a circuit/model available that is low power and could send a pin low when movement high enough to wake a microcontroller?

I think the best thing to do is to detect if the wheel moves instead of using the piezoelectric transducer

So do you pay monthly for the SIM card or what

Hey @greatscott how you learned how to make a GPS tracker?

Simsoooooooon❤

I think I’m just going to buy an air tag